Operating Guide

22 23
ADJUSTMENTS
A
Figure 34
Figure 35
Figure 36
SLIDE RESISTANCE
THROAT PLATE
See Figure 34
The slide resistance (friction) on your saw is adjustable. Use an
5mm Hex wrench. Locate the friction adjustment screw on the
saw arms (A). Turn right to tighten the sliding friction. Turn left
to loosen the sliding friction.
TIGHTEN
LOOSEN
B
C
D
Only use Delta® authorized service parts.
Using non-authorized parts can results in damage to your
machine and serious personal injury.
In the even that your throat plate needs to be replaced for any
reason, follow these instruction. See figures 35 and 36.
1. Loosen the fence lock knobs. Slide both of the upper
(adjustable) fences completely off the lower (fixed)
fence.
2. Remove the four screws (B) in the lower (xed) fence
(C). Lift the fence off of the saw.
3. Remove the six screws (D) which hold the throat plate.
Lift the throat plate off the miter arm.
4. Replace the throat plate only using a Delta® authorized
service part.
5. Tighten the six screws (D) which holed the throat plate.
6. Re-install the lower (xed) fence and tighten the four
screws (B) which hold it.