Instruction manual

Fig. 9

Fig. 10

Fig. 11

Fig. 12

5. Locate pinion knob (N) Fig. 9, spring (O), and special

screw (P).

6. Position pinion knob (N) Fig. 10, onto the back of

saw so that the teeth on the pinion knob (N) engage the

teeth on the trunnion (R). Fasten in place with special

screw (P) and spring using the supplied 4mm wrench.

7. Fasten pointer (S) Fig. 11, to the back of band saw

using the M5 x 10mm screw (T).

8. Using the supplied 4mm Hex socket wrench, re-

assemble table locking handle (F) Fig. 11, on stud and

replace screw and spring (D). NOTE: Handle (F) is spring-

loaded and can be repositioned on the stud by pulling

out the handle and repositioning it on the nut.

9. Insert M6 x 30mm screw (W) Fig. 12, down through

hole in table, as shown, and fasten in place by using M6

flat washer and M6 wing nut (X).