Manual

TILTING THE TABLE

1. The table can be tilted 45 degrees to the right. To tilt

the table, loosen lock handle (A) Fig. 31, and turn knob

(B) clockwise until desired angle is established. Then

tighten lock handle (A). NOTE: The table lock handle (A)

can be repositioned by pulling out on the handle and

repositioning it on the nut located underneath the hub of

the handle. A scale (C) and pointer (D) are provided to

indicate the degree of tilt.

Fig. 31

ADJUSTING THE TABLE POSITIVE STOPS

Positive stops are provided for the table at the 90 and 45 degree angle to the blade. To check and

adjust the positive stops, proceed as follows:

MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM THE POWER SOURCE.

1. Tilt the table to the 90 degree position as shown in Fig. 32, and tighten lock handle (A) Fig. 31.

Place a square (B) Fig. 32, on the table and against the blade and check to see if the blade is 90

degrees to the table surface. If an adjustment is necessary, proceed as follows:

2. Tilt the table slightly as shown in Fig. 31, to expose lock nut (E). Loosen lock nut and return table

to the 90° position. With the lock handle (A) loose, turn adjusting screw (F) Fig. 32, using the wrench (G)

provided until the blade is 90 degrees to the table. Then tighten lock nut (E) Fig. 32, and lock handle (A).

3. Tilt the table to the 45 degree position as shown in Fig. 33. Place a square (H) on the table and

against the blade and check to see if the blade is 45 degrees to the table surface. If an adjustment is

necessary, proceed as follows:

4. Loosen lock nut on adjustment screw (J) Fig. 33, located on the underside of the table. With lock

handle (A) Fig. 33, loose, turn adjustment screw (J) using wrench (G) provided until the blade is 45

degrees to the table. Then tighten lock handle (A), and lock nut on adjustment screw (J).

Fig. 32 Fig. 33