Manual

ADJUSTING BELT TENSION

If the drive belt on your band saw needs adjustment,

proceed as follows:

1. DISCONNECT SAW FROM THE POWER

SOURCE.

2. The belt (A) Fig. 34, drives the saw pulley from the

motor pulley. Correct tension of the belt (A) is when there

is approximately 1/4" deflection in the center span of the

belt (A) using light finger pressure. If belt tension needs

adjusted, loosen two screws (B) Fig. 35, and rotate motor

accordingly. Tighten screws (B) when adjustment is

completed.

WHEEL BRUSHES

1. DISCONNECT SAW FROM THE POWER

SOURCE.

1. Two wheel brushes (A) Fig. 36, are provided on the

machine to keep the tires free of any build-up of wood

chips. Adjustments can be made by loosening screws,

one of which is shown at (B) (which secure the brushes

to the machine) and adjusting brushes accordingly. Then

tighten screws (B).

Fig. 34

Fig. 35

Fig. 36