Instruction manual

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING SAW

The power switch is located on the left side of the

machine. To turn the machine “ON”, push the green

start button (A) Fig. 23. To turn the machine “OFF”, push

the red stop button (B).

Fig. 23

LOCKING SWITCH IN THE

“OFF” POSITION

IMPORTANT: When the tool is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use, using a padlock (C) Fig. 24 with a

3/16" diameter shackle.

Fig. 24

TILTING THE TABLE

1. The table on the band saw can be tilted 45 degrees

to the right and 10 degrees to the left. To tilt the table to

the right, loosen the two locking knobs (A) Fig. 25, tilt the

table to the desired angle as shown on the scale (D)

Figs. 25 and 26, and tighten two locking knobs (A).

2. To tilt the table (C) Fig. 26 to the left, loosen the two

locking knobs (A) Fig. 25, and tilt the table to the right

until access to the table stop (A) Fig. 26 is gained.

Remove the table stop (A) Fig. 26, and tilt the table to the

left 10 degrees. Tighten the two locking knobs (A) Fig.

25.

Fig. 25

Fig. 26