Instruction manual

ASSEMBLY

ATTACHING BELT

SANDER TABLE

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Locate the 1-3/16" long screw (A) Fig. 2, M8.4 flat

washer (B), and table locking handle assembly (C), (D),

(E) and (F). NOTE: The table locking assembly (C, D, E,

and F) is shipped assembled. For ease in assembling

table to sander, remove screw and spring (E) and (F), and

handle (D) from locking stud (C).

3. Place table (G) Fig. 3, on sander by inserting belt (H)

and platen (I) through opening (J) in table, as shown.

4. Insert 1-3/16" long screw (A) Fig. 4, into hole in

sander frame and through slot (K) underneath table and

fasten using M8.4 flat washer and stud (C), tighten the

stud (C) by hand.

5. The M8.4 flat washer (B) and stud (C) are also shown

in Fig. 5. Place handle (D) on end of stud and fasten in

place using spring (E) and screw (F) Fig. 5.

6. The table (A) is shown completely assembled to the

sander in Fig. 6. NOTE: The locking handle (B) is spring

loaded and can be repositioned by pulling out the handle

and repositioning it on the serrations located underneath

the handle. WARNING: To avoid trapping the

workpiece or your fingers between the table (A) and

the sanding belt (D), adjust the table so that it is a

maximum 1/16" from belt, between the work table

and the belt (see the section “BELT TABLE

ADJUSTMENTS”).

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6