Instruction manual

Fig. 9

Fig. 10

Fig. 11

Fig. 12

ASSEMBLING SANDING DISC

PLATE TO MOTOR SHAFT

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Assemble the sanding disc plate (A) Fig. 9, to the

motor shaft with the key (B) in the motor shaft, engaged

with the keyway (C) in the hub of the sanding disc.

3. Rotate the sanding disc until the set screw (D) Fig. 9,

is in the up position and tighten set screw (D) Fig. 9,

using wrench (E) Fig. 10, through the hole (F) in top of

guard assembly.

4. Adjust the disc guard so that the lip (G) Fig. 10,

covers the outer edge of the sanding disc, but not past

the face of the disc, and tighten the two M4X10mm

cheese head screws, one of which is shown at (H), that

attach the disc guard to the base.

ASSEMBLING LOWER

SANDING DISC GUARD

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Assemble the lower sanding disc guard (A) to the

disc base using the three M4X6mm sheet metal screws

and washers (B), as shown in Fig. 11.

ASSEMBLING SANDING

DISC DUST CHUTE

Assemble the sanding disc dust chute (A) to the disc

sander base using the M6x15mm cheese head screw

and 6.4mm external tooth washer (B), as shown in Fig.

12.