Instruction manual

BELT / DISC SANDER

TO CABINET

THE BELT / DISC SANDER IS HEAVY,

USE TWO OR MORE PEOPLE WHEN

PLACING THE BELT / DISC SANDER

ON TOP OF THE CABINET.

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Place the Belt/Disc sander on top of the cabinet.

NOTE: MAKE SURE THE DRIVE BELT ON THE

DISC/BELT SANDER IS INSERTED THROUGH THE

HOLE (A) FIG. 7.

3. Place a 5/16" lock washer onto a 5/16-18x½" hex

head screw. Insert the screw, from the inside of the

cabinet, through the hole (B) Fig. 7, and thread into the

Belt/Disc sander. Tighten the screw securely.

4. Repeat this process for the three remaining holes (B)

Fig. 7, in the cabinet and the Belt/Disc sander.

5. Place a #10 washer onto a #10-32x3/4" button head

screw. Insert the screw, from the inside of the cabinet,

through the slot (C) Fig. 7, in the dust baffle, and cabinet

and thread the screw into the Belt/Disc sander. Tighten

the screw securely.

6. Repeat this process for the three remaining slots in

the dust baffle, cabinet, and the Belt/Disc sander.

7. Fig. 8 shows the Belt/Disc sander attached to the

cabinet.

Fig. 7

Fig. 8

DUST COLLECTOR

INTAKE HOSE

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Place a hose clamp (A) Fig. 9, on each end of hose

(B).

3. Slide one end of hose (B) Fig. 10, over the hose port

Tighten the hose clamp around the hose port on the

dust baffle.

4. Slide the other end of the hose over the fan intake

port (F) Fig. 11, from the inside of the cabinet. Tighten

the hose clamp around the fan intake port.

Fig. 10 Fig. 11

Fig. 9