Instruction manual

DUST CHUTE

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Insert the dust chute (A) Fig. 16, through the inside

hole of the cabinet back panel (B) that was removed in

STEP 3 of the section “DUST BAFFLE”.

3. Align the four holes in the dust chute (A) Fig. 17, with

the four holes in the back panel (B). Insert a M4-

0.7x12mm sheet metal screw (C) Fig. 17, through the

back panel (B), and thread the screw into the dust chute

and tighten securely.

4. Repeat this process for the three remaining holes in

the back panel and dust chute.

Fig. 16

Fig. 17

2. Place a hose clamp (A) Fig. 18, on each end of hose

(B).

3. Slide one end of hose (B) Fig. 19, over the dust

collector outtake port (C). Tighten the hose clamp (A)

around the dust collector outtake port (C).

4. Slide the other end of the hose (B) Fig. 20, over the

dust chute (D), on the inside of the back panel of the

cabinet. Tighten the hose clamp (A) around the dust

chute (D).

5. Replace the back panel of cabinet that was removed

in STEP 3 of the section “DUST BAFFLE”.

Fig. 20

Fig. 18

Fig. 19

1. DISCONNECT MACHINE FROM

POWER SOURCE.

DUST COLLECTOR

OUTTAKE HOSE