Instruction manual

15
DISC SANDER TABLE
AND POINTER
1. DISCONNECT MACHINE FROM
POWER SOURCE.
2. Thread the 7/16x3" disc sanding table studs (A) Fig.
25, into the side of the disc sander.
Fig. 25
3. Place the disc sander table clamp (B) onto stud (A)
as shown in Fig. 26. Repeat this process for the
remaining stud (A) Fig. 25, on the other side of the disc
sander.
Fig. 26
Fig. 27
4. Align the table lock rail (C) Fig. 27, on the disc
sander table, with the grooves in the table clamps (B).
Fig. 28
5. Place a 7/16" flat washer (C) Fig. 28, onto each stud,
then a 1/2" spring (D), thread the disc table lock handle
(E) onto right side stud and tighten securely to hold the
disc sander table in place.
Fig. 29
6. Align the hole in the pointer (A) Fig. 29, with the
tapped hole (D) in the the left side table clamp.
7. Insert a 1/4-20x1/4" round head screw (B) Fig. 29,
through the hole in the pointer and thread into the table
clamp and tighten securely.
8. Thread the disc table lock handle (E) Fig. 28 onto left
side stud and tighten securely to hold the disc sander
table in place.
A
A
B
A
C
B
C
D
E
A
B
D
THE EDGE OF THE TABLE MUST BE
POSITIONED THE PROPER DISTANCE
AWAY FROM THE SANDING DISC TO
AVOID TRAPPING THE WORK OR
FINGERS BETWEEN THE TABLE AND
SANDING DISC. PLEASE SEE THE
SECTION “ABRASIVE DISC”.