Instruction manual

ABRASIVE DISC

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Make certain the disc assembly (A) Fig. 30, is clean,

dry, and free of any oil or grease.

3. Separate and fold back approximately half of the

adhesive backing from the abrasive disc (C) Fig. 30,

supplied with the machine. Insert the abrasive disc (C),

with the backing, between the table, and disc assembly

(A), as shown in Fig. 30, and press the top half of the

adhesive disc (C), in position.

4. Manually turn the disc assembly (A) Fig. 31, and

remove the paper backing from the abrasive disc (C),

and firmly press the abrasive disc onto disc assembly

(A).

MAKE CERTAIN THE ABRASIVE DISC

(C), IS SECURELY IN POSITION

BEFORE APPLYING POWER TO THE

MACHINE.

THE EDGE OF THE TABLE MUST BE

POSITIONED A MAXIMUM OF 1/16

INCH AWAY FROM THE SANDING DISC

TO AVOID TRAPPING THE WORK OR

FINGERS BETWEEN THE TABLE AND

SANDING DISC.

Fig. 30

Fig. 31

DUST COLLECTOR BAG

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Insert the dust collector bag hanger (A) Fig. 32 into

the two holes (B) in the top of the cabinet.

3. Place the end of the dust collector bag (C) Fig. 33,

over the dust collector hanger (A).

4. Place a hose clamp (D) Fig. 34, over the intake port

of the dust collector bag (C). Slide the intake port of the

dust collector bag over the dust chute (E) of the dust

collector. Tighten the hose clamp around the dust

collector intake port on the bag (C) and the dust chute

(E) of the dust collector.

NOTE: MAKE SURE TO REVIEW THE SECTION

“DUST PORT COVER” WHEN OPERATING THE

DUST COLLECTOR.

Fig. 32

Fig. 34Fig. 33