Instruction manual

ManualsBrandsDelta ManualsEquipment31-735

SANDING DISC TABLE 90

DEGREES TO DISC

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Loosen the two disc table lock handles, the left one

is shown at (A) Fig. 48, and move the table (B) until the

it contacts the table stop screw (C) on the left side of the

table. Tighten the lock handles.

Fig. 48

Fig. 49

3. Place a square (E) Fig. 49 on the table and against

the sanding disc. See if the table is 90 degrees to the

disc.

4. To adjust, loosen the lock handles (A) Fig. 48, and

tighten or loosen the table stop screw (C) Fig. 48 until

the table is 90 degrees to the disc.

5. Adjust sanding disc table pointer, if necessary

TILTING THE DISC

SANDER TABLE

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. To tilt the table, loosen the disc table lock handles,

one of which is shown at (A) Fig. 48, and move the table

to the desired angle and tighten the lock handles.

DISC TABLE MITER GAUGE

SLOT PARALLEL TO

SANDING DISC

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. With the table (A) Fig. 50 positioned 90 degrees to

the disc, place a square (B) in the miter gauge slot with

the blade of the square touching the sanding disc.

3. Use a pencil to mark the disc where the square (B)

Fig. 50 contacts the disc, and measure the distance

from the disc to the miter gauge slot.

4. Rotate the disc to the other end of the table. Use a

square to check the distance between the miter gauge

slot and the mark on the disc made in STEP 3. Make

sure that the distances are the same.

5. To adjust, loosen the four screws, on the table

trunnions, two of which are shown at (D) Fig. 51. Adjust

the table until the miter gauge slot is parallel to the disc.

Tighten the four screws (D).

NOTE: When making this adjustment, make sure

that the table lock handle is tightened.

MAINTAIN A MAXIMUM DISTANCE OF

1/16" BETWEEN THE SANDING DISC

AND THE TABLE.

Fig. 50

Fig. 51