Instruction manual

CIRCLE SANDING WITH DISC

1. DISCONNECT MACHINE FROM

POWER SOURCE.

A circle sanding attachment is supplied with the sander.

It enables the operator to sand circles up to 24" in

diameter. Follow the guidelines below to attach and

operate the circle sanding attachment.

2. Insert the stop block (A) Fig. 60 into the slot in the

sanding disc table. Line up the end of the outside edge

(B) of the block to the diameter of the circle shown on

the scale. Tighten the screw in the stop block with a

5/32 hex wrench (C) to hold the block (A) in place.

Fig. 60

3. Insert the guide pin (D) Fig. 61 into the center of the

oversized rough cut circle (E).

Fig. 61

4. Insert the guide pin (D) Fig. 61 into the slot (F) of the

disc sander table. Rotate the workpiece (E) Fig. 62.

continuously while sanding. A correctly sized circle is

sanded when the guide pin (D) Fig.60 contacts the stop

block, (A) Fig. 60.

Fig. 62

5. When necessary, adjust the scale (F) Fig. 63 by

loosening the two screws (G), adjusting the scale in or

out, and tightening the two screws.

Fig. 63