Instruction manual

OVERLOAD PROTECTION

The motor supplied with your sander is equipped with a

reset overload relay button (A) Fig. 67. If the motor shuts

off or fails to start because of overloading (sanding too

heavy, using a worn sanding belt or disc, using the

sander beyond its capacity), or low voltage, turn the

power switch to the “OFF” position. Let the motor cool

three to five minutes and push the reset button (A) Fig.

67. Start the motor.

Fig. 67

A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,

and Delta Authorized Service Stations. Please visit our Web Site

www

.deltamachinery.com

for a catalog or

for the name of your nearest supplier.

Since accessories other than those offered by Delta have not been tested with this product, use of such

accessories could be hazardous. For

safest operation, only Delta recommended accessories should be

used with this product.

ACCESSORIES

POWER TAKE-OFF SHAFT

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. A power take-off shaft is provided on the lower end

of the sanding belt arm to accommodate accessories.

3. For access to the power take-off shaft, remove the

two screws (B) Fig. 68, and cover (C).

4. Fig. 69 shows the power take-off shaft (A).

UNGUARDED ROTATING SHAFTS (A)

FIG 69 CAN CREATE AN ENTANGLEMENT HAZARD.

ALWAYS COVER THE POWER TAKE-OFF SHAFT

WHEN NOT USING ACCESSORIES.

Fig. 68

Fig. 69