Manual

STARTING AND

STOPPmNG MACHINE

(For 32-326 Pneumatic Line Bering Machine

Onmy}

1_ Hug the motor cord (A) Fig. 46, into outlet (B) iocated

on rear of the air and ebctrb controi box as shown.

2_ Move the motor on-off switch (C) Fig. 47, to the

"ON" position. The motor will not start at this time.

MAKE SURE THE AREA UNDER THE

HEAD IS FREE OF ALL OBSTACLES AND HANDS

BEFORE PRECEDING TO THE NEXT STEP.

3. Press in and hold the start button (D) Fig. 47. This wiii

start the machine and begin the operating cycle of the

boring head. At completion of the operating cycle, the

machine wiii shut off and you can release the start button

(D). if you release the start button (D) at any time during

the operating cycle, the motor wiii shut off and the boring

head wiii return to the up position.

4. If the motor does not start, press the reset button (E)

Fig. 47. If the machine still does not start, refer to section

"ADJUSTING AiR PRESSURE."

DO NOT USE THiS RECEPTACLE

OUTLET (B} FiG. 46, FOR ANY OTHER ELECTRmCAL

USE OTHER THAN THE UNIT MOTOR.

LOCKmNG SWITCH

IN THE "OFF" POSITION

IMPORTANT: When the machine is not in use, the switch

should be locked in the OFF position using a padlock (A)

Fig. 48, with a 3/16" diameter shackle to prevent

unauthorized use.

Fig. 46

Fig. 47

LOWERmNG BORING HEAD

(For 32-325 Line Bering Machine Onmy)

To lower the boring head (A) Fig. 49, puii down on handle

(B). After hobs have been bored, return handle to the up

position.

Fig. 48

Fig. 49