Installation Guide

ManualsBrandsDelta ManualsBathLinden 8 in. Widespread 2-Handle Bathroom Faucet in Stainless

TWO HANDLE WIDESPREAD

LAVATORY FAUCETS

LLAVES DE LAVAMANOS

EXTENDIDAS DE DOS MANIJAS

ROBINETS À ENTRAXE LONG À

DEUX POIGNÉES POUR LAVABO

Model/Modelo/Modèle

3593-▲MPU-DST

3594-▲MPU-DST

Series/Series/Seria

Para instalación fácil de su llave Delta

usted necesitará:

•LEER TODAS las instrucciones completamente

antes de empezar.

•LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

•ToREAD ALL the instructions completely

before beginning.

•To READ ALL warnings, care, and

maintenance information.

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

SILICONE

Icons

SILICONE

Icons

Pour installer votre robinet Delta

facilement, vous devez:

•LIRE TOUTES les instructions avant de débuter;

•LIRE TOUS les avertissements ainsi que toutes

lesinstructionsdenettoyageetd’entretien;

3/32” (2.38mm)

3/30/16 Rev. A

3/32" (2.38mm)

SILICONE

Icons

SILICONE

90351

www.deltafaucet.com

Linden™

3593-▲MPU-DST 3594-▲MPU-DST

▲ Specify Finish / Especifíque el Acabado / Précisez le Fini

Summary of content (8 pages)

PAGE 1
TWO HANDLE WIDESPREAD LAVATORY FAUCETS 90351 LLAVES DE LAVAMANOS EXTENDIDAS DE DOS MANIJAS Model/Modelo/Modèle 3593-▲MPU-DST 3594-▲MPU-DST Series/Series/Seria Linden™ ROBINETS À ENTRAXE LONG À DEUX POIGNÉES POUR LAVABO Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
1 A. Correct End Valve Orientation La Orientación de la Válvula Extrema Bonne configuration de la soupape B. C. 1 Hot/Caliente/Chaude Cold/Fría/Froide Open/Abrir/Ouvert Valves shown in closed position. Las válvulas en la posición cerrada. Soupapes montrées en position fermée. 5 1 3 1 3 2 2 5 3 3 1 2 2 3 4 3 4 1 Line 4 Hot Label Etiqueta Caliente Étiquette eau chaude 5 3 2 end valves (1) with gaskets (2) and bushings (3) through sink. Bushings will not be A.
PAGE 3
2 Standard Connections Conexiones Estándares Branchements Standard Custom Fit Connections Conexiones Especiales Branchements Spéciaux 2 3 2 3 2 4 3 4 1 1 1 1 4 Standard Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8".
PAGE 4
Custom Fit Connections - Plastic Sleeve Installation Instructions Conexiones Especiales - Instructions d’installations de le manchon en plastique Spéciaux Branchement - Instrucciones para la Instalación del la Manga Plástica Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2.
PAGE 5
B. E. D. C. 1 SIL NE I CO 3 A. 1 2 3 2 3 2 1 1 1 F. G. 4 2 2 H. 5 5 4 3 2 6 1 2 1 3 2 1 7 Step 3b Metal Pop-Up A. Remove stopper (1) and flange (2). B. Screw nut (1) all the way down. Push washer (2) and gasket (3) down. C. Remove tailpiece (1) from body (2), add plumber tape (3), replace tailpiece. D. Apply silicone to underside of flange (1). Insert body (2) into sink. Screw flange (1) into body (2). E. Pivot (1) must face faucet.
PAGE 6
4 1 To Change the Position of Handle Stop (5). Para cambiar la posición de el tope (5). Pour changer la position de la butée (5). 3 Cold Fría Froide Hot Caliente Chaude 3 5 5 2 5 4 5 3 Arrow faces spout on both hot & cold sides. 5 Hot Caliente Chaude 1 4 2 Remove aerator (1) using supplied wrench (2) and turn faucet handles (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute.
PAGE 7
H293▲ RP70648▲ Lift Rod Finial Pomo de la barra de alzar Grain de la Tirette RP40267▲ Lift Rod Barra de Alzar Tige de Manoeuvre *RP84705 Set Screw Covers (1 Set Screw / 1 Gray / 1 Black) Conjunto tapas de los tornillos (1 Tornillo de Ajuste / 1 Gris / 1 Negro) Covercles des vis de réglage (Vis de Calage / 1 Gris / 1 Noirs) RP60352 Bonnet Nuts Bonetes/Capuchones Chapeaux Filetés RP41896 Glide Ring Aro para Deslizar L’anneau de Glissement * Optional finished set screw covers RP72714▲ available, must be o
PAGE 8
CLEANING AND CARE Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.