Full Product Manual

ASSEMBLY
RIP FENCE
ON-BOARD STORAGE
Attach the handle to the fence cam.
The Rip Fence
PC24
slides onto the rear fence rail so that the hook is under the rear rail and rides on the front Fence Guide. The fence
locks in place by applying pressure in a downward motion on the Rip Fence Handle
PC15
. Rip fence alignment should be checked prior
to using your saw. To check alignment of the rip fence, see alignment instructions on page 29.
The Delta #36-5000 T2 series contractor table saws comes with on-board storage for the provided Miter Gauge
PC6
, Riving Knife,
Blade Wrench
PC9
, Push Stick
PC7
and Rip Fence
PC4
. There is also on-board storage for spare saw blades (sold separately). The miter
gauge, spare blade and blade wrench storage areas are located on the right side panel of the machine and come pre-installed.
On-board storage for the rip fence and the push stick is located on the left side of the saw.
MITER GAUGE
Insert Miter Gauge
PC6
into each miter slot to make sure it slides freely. See Adjusting the Miter Stops section on page 28 for
adjustment of miter gauge accuracy.
SECURING SAW TO FLOOR
This saw is designed for portability. DO NOT attempt to use the saw to cut a large or cumbersome workpiece
without first taking appropriate steps to protect against tipping the saw. Examples of appropriate steps include the use of support
tables and/or securing the saw legs to the floor by replacing the saw feet with connecting bolts or by attaching the legs to a floor
mounted bracket with u-straps.
25