Use and Care Manual

ASSEMBLY

Avoid contact with blade teeth. Keep blade

stored or lowered when possible.

• Do not lift saw without help. Hold it close to your body

while lifting. Keep knees bent and lift with your legs, not

your back.

• Fully assemble saw with leg assembly prior to use. Leg

assembly is an integral and necessary part of the support

structure for this saw.

• Do not modify saw, or create accessories not recommended

for use with this saw.

• Make sure power switch is in “OFF” position before

connecting to power supply.

• Do not connect to power supply until assembly is complete

TOOLS REQUIRED FOR ASSEMBLY (not included)

• Slotted screwdriver

• Phillips head screwdriver

• 8mm wrench

• 10mm wrench

• 12mm wrench

• 13mm wrench

• 3/8-inch wrench

STAND

1. Connect the two tube legs by inserting the end of the

left leg (A) into the end of the right leg (B) as shown in

Figure 1. Secure with a M8 x 70mm carriage bolt, lock

washer and nylock nut and tighten.

2. Insert the four open ends of the tube legs into the

leg collars (C) as shown. Secure each leg with a M6 x

72mm bolt and nut.

3. Attach the back and front leg support panels (D) to the

legs using four M6 x 10mm self-tapping bolts.

NOTE: Place screw through small hole first.

Snug down but do not tighten this screw.

Place rest of the screws through the slots and start threading

into holes on mount tab on stand. Once all screws are started,

tighten all four sufficiently to hold plate firmly. These are self-

tapping screws and may be hard to thread at first. Follow this

procedure for all four panels or 16 screws.

FIGURE 1

• 7/16-inch wrench

• 1/2-inch wrench

• 9/16-inch wrench

• 6mm Allen hex wrench

• 5/32-inch Allen wrench

• 3/16-inch Allen wrench