Use and Care Manual

ASSEMBLY
TOOTH
DIRECTION
K
FRONT OF
SAW
ARBOR
SHAFT
a
FIGURE 13
FIGURE 14
Place blade (K) on the arbor shaft with the teeth on the blade pointing toward the front of the saw. Place flanged washer on the
shaft with the large side of the washer against the blade, then secure blade assembly with nut. See Figure. 13.
Tighten nut with blade wrenches (a). Open end wrench will fit on the arbor shaft between the inner flange washer and the motor
assembly (if neccessary, turn arbor shaft to align flats on the arbor shaft to the wrench). Closed end wrench will fit on the nut. See
Figure 14.
Return wrenches (a) to onboard storage location. Position the riving knife in the “Thru-cut” position prior to installation of thoat
plate.
Details for positioning the riving knife are on page 44 RIVING KNIFE POSITION AND ALIGNMENT Section. See Figure 15.
17