Instruction manual

Installing Drive Belt

Figure 11

Lift up on motor (A) and assemble drive belt ( B) to the

arbor pulley (C) and the motor pulley (D). The weight of

the motor will provide the correct tension.

Figure 12

This view shows the left extension wing (A) attached. The

right extension wing mounting screws (3), locking washers

(3), and flat washers are aligned with the three threaded

mounting holes (B).

Figure 13

Using the supplied hex head screws, lock washers, and

flat washers (A), attach the extension wing (B) to the saw

table.

NOTE: Loosely tighten screws until next step is complete.

Fig. 11

Fig. 12

Attaching Extension Wings to Saw Table

Figure 14

Using a straight edge (A), check the level of the extension

wing (B) with the saw table (C). Once this is completed,

tighten all three hex head screws.

Fig. 14

Fig. 13