Instruction manual

Figure 19

Mount sliding extension table (A) into front and rear rail

channels (B) using adjustment pads (C). Adjust pads for a

smooth but snug fit.

Figure 20

Using a straight edge (A), check the level of the sliding

table (B) with the right extension wing (C). Once this is

completed, tighten all screws.

Figure 21

Fasten the splitter mounting bracket (A) to the rear trunion

using supplied hex head screws (2), lockwashers (2), and

flat washers (2). Do not completely tighten the two screws

(B) at this time.

Fig. 19

Fig. 20

Figure 22

Raise the saw arbor to its hightest position. Using a

straight edge (A), check to see if the inside splitter bracket

(B) is aligned with the inner arbor flange (C).

Fig. 22

Fig. 21

Blade Guard and Splitter Assembly

DISCONNECT TOOL FROM POWER

SOURCE.