Instruction manual

Figure 23

If alignment is necessary, loosen the two screws (A), align

bracket (B) with the arbor flange and tighten screws (A).

Loosely assemble large washer and hexhead screw (C) to

the inside splitter bracket (B).

Figure 24

Install the blade guard and splitter assembly (A) between

the large washer (B) and the splitter bracket. Tighten hex

head screw.

Figure 25

Fasten the rear of the blade guard and splitter bracket

assembly (A) to the rear splitter mounting bracket (B)

using supplied carriage head screw (1), lockwasher (1),

flat washer (1), and hex nut (1). Securely tighten screw

assembly(C).

Fig. 23

Fig. 24

Figure 26

The splitter (A) has a notch (B) cut in the top edge. This

feature will enable the blade guard to stay in the raised

position to make blade changing easier. Raise the front of

blade guard (C) until the rear edge slips into notch (B). The

blade guard will stay in this position.

Fig. 26

Fig. 25