Instruction manual

19
Rip Fence Adjustments
DISCONNECT TOOL FROM POWER
SOURCE.
Figure 49
Slide fence (A) against one edge of the miter gage slot (B).
Lock the fence handle (C). The edge of the fence should
be parallel with the edge of the miter gage slot.
Figure 50
If an adjustment is necessary loosen the four hex screws
(A). Make the necessary correction, then tighten screws
(A).
Figure 51
Once the fence is aligned with the miter gage slot, raise
the saw blade (A) to its highest position. Slide fence (B)
against blade and lock fence in that position by pushing
down on locking handle (C).
Fig. 49
Fig. 50
Figure 52
The right cursor witness line (A) should line up with the
“Zero” mark on scale (B). If it does not, loosen screw (C)
and adjust cursor (D). Tighten screw. For fence operations
left of the blade, repeat procedure but use left cursor.
Fig. 52
Fig. 51