Instruction manual

21
MAINTENANCE
Changing the Saw Blade
DISCONNECT TOOL FROM POWER
SOURCE.
Figure 56
Remove table insert (A) and raise saw blade (B) to its
maximum height.
Figure 57
Place the open end wrench on the flats of the saw arbor to
keep the arbor from turning. Using the box wrench, turn
arbor nut toward the front of the saw. Remove arbor nut,
blade flange, and saw blade.
Assemble the new blade, making sure the teeth point
down at the front of the saw table, and assemble outside
blade flange and arbor nut. With open end wrench on the
flats of the arbor, tighten arbor nut by turning box wrench
counterclockwise. Replace table insert.
Fig. 56
Fig. 57
Use only 10” Diameter Blades with 5/8” Arbor Holes, rated
at 3450 RPM or Higher