Instruction manual

9
ASSEMBLY INSTRUCTIONS
FOR YOUR OWN SAFETY, DO NOT
PLUG SAW INTO OUTLET UNTIL THE TOOL IS
COMPLETELY ASSEMBLED AND YOU READ AND
UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
Installing Leveling Pads
Figure 7
With basic saw unit (A) turned base up, thread the (4)
adjustable leveling pads (B) into the bottom of cabinet.
Use locking nuts to secure pad position once saw is
upright and leveled.
Figure 8
Place blade tilting handwheel (A) onto shaft (B). Make
certain slot (C) in handwheel is engaged with roll pin (D)
on the shaft. Thread locking knob (E), in Fig. 9, onto shaft
(B).
Figure 9
Assemble the blade raising handwheel (A) to the front of
the saw in same manner.
Fig. 7
Fig. 8
Fig. 9
Blade Tilting and Raising Handwheels
Figure 10
Cut tape holding packing block (A) in place. Gently lower
motor (B) and remove Block.
Motor Packing Block
Fig. 10