Use and Care Manual

FIG. 42

FIG. 43

FIG. 44

FIG. 45

ADJUSTING 0° AND 45° POSITIVE STOPS

There are built in stops that can position the blade at 0° and 45°.

If the blade is not properly at 0° when it is resting on the stop:

1. Adjust blade to 0° stop and back it off slightly.

2. Loosen the bevel stop nut (UU) slightly using supplied arbor

wrench.

3. Using blade tilting handwheel (CC), position blade at exactly

0°.

4. Use 4 mm hex wrench inside the bevel stop nut (UU)to turn

the stop into place. NOTE: The stop can be rotated either

way to position stop against the trunnio

5. Hold the stop in place and tighten the bevel stop nut (UU)

with the supplied arbor wrench.

6. Verify position by beveling off and then coming back to the

stop to check blade position.

NOTE: To adjust the 45° stop, use the other bevel stop nut (TT)

and follow the same procedure above.

ADJUSTING BLADE TILT SCALE

Using a combinaton square, turn blade tilting handwheel until

the blade is set perfectly at 45

°. If the blade tilt scale is not

pointing to 45

°, follow these steps:

1. Remove the magnetic cover (VV) Fig. 43.

2. Remove the screw (WW)

Fig. 44 using a T20 wrench and

remove the center cap (XX).

3. Loosen angle indicator screw (YY) Fig. 45.

4. Put red pointer on 45

° and tighten screw while holding

the back face so the pointer stays on 45

°.

5. Replace center cap (XX) Fig. 44. Make sure the rubber

O-ring stays seated behind cap.

6. Put magnetic cover (VV) Fig. 43 back on.