Owner`s manual

OPERATING CONTROLS AND ADJUSTMENTS

Fig. 23

Fig. 24

Fig. 25

ON/OFF SWITCH

The on/of f switch (A) Fig. 23, is located at the front lef t

side of the jointer . To give power to the jointer, move the

switch (A) to the UP position. To turn the power OFF,

move the switch (A) to the down position.

LOCKING SWITCH IN

T H E OFF POSITION

W e suggest when the jointer is not in use, that the switch

be locked in the OFF position for safety and to prevent

unwarranted use. This can be done by pulling the switch

toggle (B) outward as shown in Fig. 24. W ith the switch

toggle (B) removed, the switch (A) will not operate. How-

ever, should the toggle switch (B) be removed while the

jointer is running, it can be turned of f, but cannot be

rest arted again without inserting the switch toggle (B).

OVERLOAD PROTECTION

The jointer is equipped with a reset overload relay button

overloading (jointing too deep; working with dull knives;

using the jointer beyond it s cap acity), move the power

switch to the of f position. Let the motor cool three to five

minutes, then push the reset button (C) to reset the over -

load device. The motor can then be turned on again in

the usual manner.

KNIFE A N D TABLE

ADJUSTMENTS

In order to do accurate work, the knives must be exactly

level with the out feed t able. To check and adjust if

necessary, proceed as follows:

1. MAKECERTAIN THE MACHINE IS DISCONNECT-

EDFROMTHEPOWERSOURCE.

2. Loosen locking knob (B) Fig. 25, and lower the in-

feed t able by turning the adjustment knob (A) counter -

clockwise and swing the cutterhead guard out of the way.

3. Place a steel straight edge on the out feed t able ex-

tending out over the cutterhead, as shown in Fig. 26.

4. Carefully rot ate the cutterhead by hand. The knives

should just touch the straight edge.

Fig. 26