Owner`s manual

ADJUSTING

DEPTH-OF-CUT

The jointer can be set to cut any depth from a very thin

shaving to 3/8 . If a cut deeper than 3/8 is desired, the

cut should be made in three or more p asses.

1. MAKECERTAIN THE MACHINE IS DISCONNECT-

EDFROMTHEPOWERSOURCE.

2. To adjust the depth-of-cut, loosen lock knob (B) Fig.

32. T urn adjustment knob (A) counterclockwise to lower

the infeed t able or clockwise to raise the infeed t able.

The ring (C) Fig. 32, indicates the depth-of-cut on scale

(D). T ighten lock knob (B), af ter adjustment is made.

3. To check if the ring (C) Fig. 32, is aligned correctly to

the depth-of-cut scale (D), place a straight edge on the

out feed t able and extend it over the infeed t able as

shown in Fig. 33.

4. Loosen locking knob (B) Fig. 34, and raise the infeed

table by turning adjustment knob (A) clockwise until the

infeed t able touches the straight edge. The ring (C) Fig. 34,

should line up with zero on the depth-of-cut scale (D).

5. If the ring on the adjustment knob does not line up

with zero on the depth-of-cut scale, make the following

adjustments:

[a] Loosen set screw with wrench (E) inside adjust-

ment knob (A) Fig. 34, as shown.

[b] T urn knob (A) Fig. 34, clockwise or counterclock-

wise as necessary until the ring (C) lines up with

the depth-of-cut scale (D).

[c] T ighten set screw that was loosened inside

adjustment knob in STEP [a].

6. IMPORTANT:The jointer features an automatic

table stop (F) Fig. 35, which does not allow the infeed

table to be lowered by more than 1/8 increments. This

also act s as a safety feature should the operator fail to

lock the t able af ter setting the depth-of-cut. If it is ever

necessary to lower the infeed t able more than 1/8 , the

stop (F) must be pushed upward while adjusting the t able

height.

Fig. 32

Fig. 33

Fig. 34

Fig. 35