Owner`s manual

Fig. 36 Fig. 37

Fig. 38

Fig. 39

FENCE ADJUSTMENTS

The fence can be easily moved across the t able and can

tilt 45 degrees lef t or right at any position on the t able.

1. To move the fence across the t able, loosen lever (A)

Fig. 36, slide the fence (B) to the desired position and

tighten locking lever (A).

2. T o tilt the fence (B) Fig. 36, loosen lever (C) and tilt

the fence to the desired angle and tighten lever (C).

NOTE: Levers (A) and (C) are spring-loaded and can be

repositioned by pulling outward on the levers and re-

positioning them on the serrated nut located underneath

the levers.

3. The fence on the jointer features adjust able positive

stop s (D) Fig. 37, and a stop link (E) at 90 degrees right

and lef t. Check the fence angle at 90 degrees with a

square (F) as shown in Fig. 38. If an adjustment is neces -

OPERATIONS

The following directions will give the beginner a st art on

jointer operations. Use scrap pieces of lumber to check

settings and to get the feel of the operations before

attempting regular work.

W ARNING: A LW AYS USE CUTTERHEAD GUARD A N D

KEEP HANDS AW AY FROM THE CUTTERHEAD.

ALW AYS USE PUSH BLOCKS WHENEVER POSSIBLE.

PLACEMENT OF HANDS

DURING FEEDING

At the st art of the cut, the lef t hand holds the work firmly

against the infeed t able and fence, while the right hand

pushes the work toward the knives. Af ter the cut is under -

w a y, the new surface rest s firmly on the out feed t able as

shown in Fig. 39. The lef t hand should then be moved to

the work on the out feed t able, at the same time main -

taining flat cont act with the fence. The right hand press -

es the work forward, and before the right hand reaches

the cutterhead, it should be moved to the work on the

out feed t able.

CAUTION: NEVER PASS HANDS DIRECTLY OVER THE

CUTTERHEAD.

sary, turn set screw (D) in or out until it cont act s the stop

link (E) when the fence is set at 90 degrees to the t able.

4. Repeat this procedure to check the positive stop s (D)

Fig. 37, at 45 degrees right and 45 degrees lef t.