Installation Guide

(7B)(7A)
5 6
Wrap the shower arm threads
with plumber tape before
installing into plumbing
fitting. Hand tighten hose
end to shower arm (or water
supply) by turning clockwise.
Then fully tighten with an
adjustable wrench or pliers.
Use a soft cloth between the
jaws of the tool and hose
connector to protect the
finish.
Carefully tighten
other end of hose
to the hand shower.
Place the hose from
the hand shower
into the holder (or
bracket) section of
the arm mount and
slip down. Do not
force. The hose
takes a “natural
drape” after warm
water has been run
through it.
7 8
The arm mount unit (for the
hand shower) of the Wall Grab
Bar can be adjusted (7A) by
pushing up or down on the
extended Paddle to move the
unit up or down (on vertical or
angled Grab Bar installations)
and left or right (on horizontal
installation). After positioning
as desired, flip the Paddle into
the straight (locked in) position.
In addition, (7B) the arm mount
can be adjusted by lightly
tapping on the base of the arm
mount unit.
The arm mount unit also
can be twisted clockwise
or counter-clockwise for
desired positioning for
the hand shower.
9 10
Additional adjustments of the arm mount unit
is available with the holder section of the arm
mount unit. This holder can be turned clockwise
or counter-clockwise for desired mounting of the
hand shower.
Do not force the
handle in or out of
the arm mount unit.
The hand shower is
easily removed from
the arm mount by
lifting the handle
upward.
Note: This “water saver” shower is designed
to limit water usage to 2.5 gallons per minute
maximum. A flow control disc is pre-installed in
the end of the handle where the handle attaches
to the hose. The hand shower also contains dual
check valves for back-flow protection.
Cleaning Instructions
To clean the hand shower face plate: Remove the shower handle from the
hose. Soak the hand shower in a 50/50 solution of white vinegar and water for
30 minutes to dissolve mineral buildup. Reassemble; do not overtighten the
handle to the hose. Turn on the shower to wash the impurities out of the hand
shower.
To clean the Wall Grab Bar or Arm Mount Unit: Wipe with soft, damp cloth
- do not use detergent or cleansers that may be harmful to the finish.
All parts and finishes of the Delta® faucet are warranted to the original consumer purchaser to
be free from defects in material & workmanship for as long as the original consumer purchaser
owns their home. Delta Faucet Company recommends using a professional plumber for all
installation and repair.Delta will replace, FREE OF CHARGE, during the warranty period, any part
or finish that provesdefective in material and/or workmanship under normal installation, use and
service. Replacement parts may be obtained by calling 1-800-345-DELTA (in the U.S. and Canada)
or by writing to:
LIFETIME FAUCET AND FINISH LIMITED WARRANTY
© 2011, Masco Corporation of Indianawww.deltafaucet.com
INCURRED IN INSTALLATION, REPAIR OR REPLACEMENT AS WELL AS ANY OTHER KIND OF LOSS
OR DAMAGES ARE EXCLUDED. Proof of purchase (original sales receipt) from the original
consumer purchaser must be made available to Delta for all warranty claims. THIS IS THE
EXCLUSIVE WARRANTY BY DELTA FAUCET COMPANY, WHICH DOES NOT MAKE ANY OTHER
WARRANTY OF ANY KIND, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY.
This warranty excludes all industrial, commercial and business usage, whose purchasers are
hereby extended a five year limited warranty from the date of purchase, with all other terms of
this warranty applying except the duration of the warranty. This warranty is applicable to Delta®
faucets manufactured after January 1, 1995.Some states/provinces do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not
apply to you. Any damage to this faucet as a result of misuse, abuse or neglect, or any use of
other than genuine Delta® replacement parts WILL VOID THE WARRANTY.This warranty gives you
specific legal rights, and you may also have other rights which vary from state/province to
state/province. It applies only for Delta® faucets installed in the United States of America,
Canada and Mexico.
In the United States: In Canada:
Delta Faucet Company Masco Canada
Product Service Technical Service Centre
55 E. 111th Street 350 South Edgeware Road,
Indianapolis, IN 46280 St.Thomas,ON.N5P 4L1
This warranty is extensive in that it covers replacement of all defective parts and even finish,
but these are the only two things that are covered. LABOR CHARGES AND/OR DAMAGE