Installation Guide

8
P/N 27794 09/13
WALL INSTALLATION (Continued)
15. Apply Sealant
S
APPLY SEALANT to all seams.
IMPORTANT! Follow manufacturer’s instructions for
sealant dry time before use.
◘ Install plumbing fixtures and fittings per manufacturer’s
instructions. Check for leaks at all connections before use.
!
CAUTION: If installing nished wall material, do not
screw into anges or product damage will occur.
13. Secure Side Panel
◘ Install side panel, sliding the side panel into gap between
wall and back panel, pressing firmly into corner and against
studs. Push in and down until panel tops are even and
curved area on side panel fits against back panel.
IMPORTANT! Gaps between anges and studs must be
less than 1/8". Insert shims to ll gaps.
◘ Secure top and side flanges to studs with 1-1/4” screws.
! CAUTION: Use panhead or roundhead screws. Do not
overtighten screws, this can cause panel to crack.
◘ Repeat steps 12 and 13 to secure other side panel.
14. Brace Side Panels
◘ Install temporary braces to hold side panels tight against
studs while adhesive dries.
◘ Protect surface of wall set where it will contact braces.
!
CAUTION: Braces should be placed on wall studs to
prevent wall panel deection.
IMPORTANT! Follow manufacturer's instructions for
adhesive dry time before removing brace.
ShimShim
1-1/4"
(3,17cm)
1-1/4"
(3,17cm)