Installation Sheet

ManualsBrandsDelta ManualsBathroom AccessoriesDelta Wall Mounted Pivoting Toilet Paper Holder

5/22/2018

102830

You may need

Usted puede necesitar

Articles dont vous pouvez avoir besoin:

Parts and Hardware Included

Piezas y hardware incluidos

Pièces et matériel inclus

Set of Mounting Hardware

Six (6) #10 x 2-1/2” Wood Screws

Juego de Herramientas de Instalación

Seis (6) #10 x 2-1/2” Tornillos de Madera

Set de Matériel de Montage

Six (6) Vis à Bois #10 x 2-1/2”

Wall Anchor (1)

Anclaje de pared (1)

Ancrage mural (1)

ADA COMPLIANT GRAB BAR WHEN

INSTALLED PER THE ACCESSIBILITY

GUIDELINES OF THE ACT.

ADA DE CUMPLIMIENTO CON

LA BARRA DE AGARRE AL

INSTALARSE SEGÚN LAS PAUTAS DE

ACCESIBILIDAD DE LA ACT.

BARRE D’APPUI CONFORME ADA

LORSQU’ELLE EST INSTALLÉE

PAR LES DIREC TIVES SUR

L’ACCESSIBILITÉ DE L’OPÉRATION.

102830 Rev. A

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

Specify Finish

Especifíque el Acabado

Précisez le Fini

TISSUE HOLDER WITH ASSIST BAR

PORTE-MOUCHOIRS AVEC BARRE

D'ASSISTANCE

SOSTENEDOR DEL TEJIDO CON LA

BARRA DE AYUDA

41350▲

41450▲

41550▲

Models/Modelos/Modèles

41350▲

41450▲

41550▲

Series/Series/Seria

www.deltafaucet.com

1-800-345-DELTA (3358)

customerservice@deltafaucet.com

Summary of content (6 pages)

PAGE 1
TISSUE HOLDER WITH ASSIST BAR PORTE-MOUCHOIRS AVEC BARRE D'ASSISTANCE SOSTENEDOR DEL TEJIDO CON LA BARRA DE AYUDA 102830 Models/Modelos/Modèles 41350▲ 41450▲ 41550▲ Series/Series/Seria 41350▲ Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. p Specify Finish Especifíque el Acabado Précisez le Fini 41450▲ ADA COMPLIANT GRAB BAR WHEN INSTALLED PER THE ACCESSIBILITY GUIDELINES OF THE ACT.
PAGE 2
1 B. A. PRIOR TO INSTALLATION: 1. Remove grab bar & components from packaging. 2. Determine desired installation location and orientation. For stud-mounted installations, use a stud finder to verify locations of studs. 3. Place product against wall at desired location. If mounting product vertically or horizontally, use a level to verify that product is properly oriented. 4. Use a pencil and mark the centers on each side of the product for the mounting locations. (Fig. 1A) 5.
PAGE 3
WALL ANCHORMOUNTING MOUNTINGDIRECTIONS DIRECTIONS WALL ANCHOR 2 A. DO NOT install supplied wall anchors into wallboard less than ½” or greater than 2 ½” thick. DO NOT install supplied wall anchors into wallboard that has been subjected to water damage or decay. DO NOT install supplied wall anchors into a wood stud. NOTE: Opposing end will need to be mounted using the Stud Mounting Directions in Section A, steps 4-6. It is suggested to locate and mark opposing stud end. 1. 2. 3. 4. 5. 6. B. 1. 2. A.
PAGE 4
D. C. 1. 2. 1. 2. 1. 2. Hold on tightly to the flange and keep pressure on the bar behind the wall to ensure that the bar stays upright with the longest part of the bar pointing upward. The bar behind the wall must always be upright and the longest part must be pointing upward for the anchor to perform properly. As you hold the flange and apply pressure to the bar by pulling outward, insert a 3” machine screw into the center hole of the flange.
PAGE 5
WARNING GRAB BAR MAY NOT PROVIDE DESIGNED AMOUNT OF SUPPORT UNLESS THESE INSTALLATION INSTRUCTIONS ARE STRICTLY FOLLOWED. For proper installation, at least one end of Grab Bar MUST be positioned over a wall stud. For solid support, at least two (2) of the three (3) screws on the end of the Grab Bar MUST go through the wallboard or tile and be tightly secured into the wall stud. Given standard stud sizes, only two (2) of the three (3) screws may screw into the wall stud.
PAGE 6
LIMITED WARRANTY ON DELTA® ACCESSORIES Delta Faucet Company for all warranty claims unless the purchaser has registered the product with Peerless Faucet Company. This warranty applies only to Delta® accessories manufactured after January 1, 1995 and installed in the United States of America, Canada and Mexico.