Installation Guide

5
Drill pilot holes through wall jambs using a 1/8" drill bit. Install wall jambs using #8 1-1/2" panhead screws.
NOTE: Screws must go into studs or use drywall anchors.
Insert glass panels into wall jambs.
NOTE: Hinge holes are located on side of left stationary
glass panel for left pivoting door installation.
For right pivoting door installations, install the stationary
glass panel with hinge holes on the right side of shower
enclosure.
Check that stationary glass panels are level. Make
adjustments if needed.
NOTE: The joint between the stationary glass panels
and wall jambs will accommodate walls that are not
perfectly plumb. Adjust stationary panels so that the
vertical edge of the glass is plumb.
5
1/8"
7
TOP VIEW
8
1
1
1
1
1
1
6
B27795 Rev. C