Installation Guide

INSTALLATION

BEFORE YOU BEGIN BASE INSTALLATION

Mark unit position on floor and through drain

opening.

Mark the locations of the studs on the flange of the

base.

NOTE: These marks are used to verify base location

after drain is installed in Step 4 and outline where

adhesive is applied.

Position base in corner. Check for level left to right and

front to back.

IMPORTANT: If the subfloor is not flat and level, use

leveling compound or mortar bed to ensure that the

base is level (shown in Step 5).

NOTE: If using the matching wall set, install the base

against drywall or green board, not against the studs.

This is so that the wall set does not overhang the base.

Before base installation, check that the apron retainers are secure. The retainers should fit snuggly on the posts on the base and the

tabs should be inserted into the slots on the retainers. Adjust if necessary.

78326 Rev. C

Apron

Retainer

Tabs