Installation Guide

4
Ensure that the waste pipe is properly located to
align with the drain assembly (not included).
The opening should be 5" in diameter. The drain pipe
should extend 5/8" above the subfloor.
Install drain following manufacturer's instructions.
CAUTION: Plumber’s putty will degrade base
material. DO NOT use plumber’s putty to seal
between drain andbase. Use sealant or gasket.
Remove base from corner and drill 3/16" pilot holes in
flanges where stud locations have been marked.
NOTE: It is recommended to put masking tape on the
base to protect the surface from drill chuck damage.
5
5/8"
(1,59cm)
5"
(12,7cm)
1
2
4
Use a stud finder to locate studs. Mark stud locations on
wall and base.
NOTE: If studs cannot be located, use dry wall anchors.
For base installation
with matching wall set only.
78326 Rev. C
3