Instructions / Assembly

4
Ensurethatthewastepipeisproperlylocatedto
alignwiththedrainassembly(notincluded).
Theopeningshouldbe5"indiameter.Thedrainpipe
shouldextend5/8"abovethesubfloor.
Installdrainfollowingmanufacturer'sinstructions.
CAUTION: Plumber’s putty will degrade base
material. DO NOT use plumber’s putty to seal
between drain andbase. Use sealant or gasket.
Removebasefromcorneranddrill3/16"pilotholesin
flangeswherestudlocationshavebeenmarked.
NOTE:Itisrecommendedtoputmaskingtapeonthe
basetoprotectthesurfacefromdrillchuckdamage.
5
5/8"
(1,59cm)
5"
(12,7cm)
1
2
4
Useastudfindertolocatestuds.Markstudlocationson
wallandbase.
NOTE:Ifstudscannotbelocated,usedrywallanchors.
For base installation
with matching wall set only.
78326Rev.B
3