Install Instructions

ManualsBrandsDelta ManualsKitchenLinden Single-Handle Pull-Out Sprayer Kitchen Faucet with Multi-Flow in Arctic Stainless

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta

usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and maintenance

information.

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant de débuter;

• LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien.

Model/Modelo/Modèle

4353-DST

Series/Series/Seria

SILICONE

Icons

08/23/2018 Rev. Dwww.deltafaucet.com

WARNING: THIS FAUCET IS NOT TO BE USED WITH PORTABLE

DISHWASHERS! / ADVERTENCIA: ¡SESTA LLAVE NO SE

DEBE UTILIZAR CON MAQUINAS LAVAPLATOS PORTATILES! /

AVERTISSEMENT: ON NE DOIT PAS BRANCHER UN LAVE-VAISSELE

PORTATIF SUR CE ROBINET!

SINGLE HANDLE PULLOUT KITCHEN FAUCETS

LLAVES EXTRAÍBLES DE AGUA PARA COCINAS

ROBINETS À UNE MANETTE À BEC-DOUCHETTE

RÉTRACTABLE POUR ÉVIERS DE CUISINE

1/8" (3.17mm)

SILICONE

Icons

85216

Summary of content (12 pages)

PAGE 1
85216 SINGLE HANDLE PULLOUT KITCHEN FAUCETS LLAVES EXTRAÍBLES DE AGUA PARA COCINAS ROBINETS À UNE MANETTE À BEC-DOUCHETTE RÉTRACTABLE POUR ÉVIERS DE CUISINE Model/Modelo/Modèle 4353-DST Series/Series/Seria TEF LON LIC ON You may need/Usted puede necesitar/ Articles dont vous pouvez avoir besoin: SI WARNING: THIS FAUCET IS NOT TO BE USED WITH PORTABLE D I S H WA S H E R S ! / A D V E R T E N C I A : ¡ S E S TA L L AV E N O S E DEBE UTILIZAR CON MAQUINAS LAVAPLATOS PORTATILES! / AVERTISSEMENT: ON NE D
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish. All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.
PAGE 3
1 B. A. C. A. 1 2 1 B. 3 2 3 2 1 1 3 1 1 2 2 2 Faucet Installation Faucet Installation DECK MOUNT STYLE A. Place baseplate shanks (1) through mounting holes in deck. Option: If sink is uneven, use silicone sealant under the baseplate. CENTER MOUNT STYLE C. Secure faucet to sink with mounting nut and washer (1). Tighten securely by hand. Using a Phillips screwdriver, tighten locking screws (2). Install locknuts (3) and hand-tighten. A. Install round escutcheon (1) onto faucet (2).
PAGE 4
2 B. A. 2 OR 2 1 O 2 OU 3 1 3 4 1 2 4 A. Water Line Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (3) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 5
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 6
3 4 1 B. A. 1 2 4 3 2 1 5 3 Flush Supply Lines Place a bucket below the outlet fitting and move the valve handle (1) to the open mixed position.Then, while holding the outlet tube (2) over the bucket, slowly open and close the supply stops (3). This will prevent debris from being lodged in the hose and sprayer. Hose Installation A. Feed hose assembly (1) through hub (2). Slide Side View Vista lateral Vue latérale hose weight (3) over end of hose assembly (1). B.
PAGE 7
5 6 2 6 3 4 1 5 Soap Dispenser Installation Remove nut (1). Separate head (2) from body (3). Insert body (3) and gasket (4) through selected hole in sink. Make sure gasket (4) is properly seated in the base. Secure body to sink with nut (1). From under the sink screw the bottle (5) onto the body assembly shank. Insert pump (6) into head (2), then drop into body (3). NOTE: To fill, lift the head and pump assembly out of the bottle and pour not more than 8 oz. into bottle.
PAGE 8
7 1 2 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold” to “mixed hot/cold”). The handle limit stop can be adjusted by the homeowner once the faucet is installed.
PAGE 9
1/8" (3.17mm) 1 2 3 1 Maintenance If faucet leaks from under handle: Remove handle and unthread trim cap (1). Using a wrench, ensure bonnet nut (2) is tight. If leak persists–SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (2) is tightened securely with a wrench.* If faucet leaks from spout outlet–SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (2) is tightened securely with a wrench.
PAGE 10
CLEANING AND CARE Care should be given to the cleaning of this product. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel. LIMPIEZA Y CUIDADO DE SU LLAVE Tenga cuidado al ir a limpiar este producto. Aunque su acabado es sumamente durable, puede ser afectado por agentes de limpieza o para pulir abrasivos.
PAGE 11
RP40650 Set Screw Tornillo de Presión Vis de calage RP60966p Button / Botón / Bouton RP60965p Lever Handle Assembly Manijas de Palanca Manette RP51502p Cap Casquillo Embase RP51503 Bonnet & V-Ring Bonete y Aro-V Chapeau et Joint à lèvres RP50587 Valve Assembly Ensamble de la válvula Soupape RP60964p Hub Assembly Ensamble de Cubo Boîter RP60963p Spray & Hose Assembly Rociador y Ensamble de la Manguera Douchette et Tuyau Souple RP63264 Adapters (10) 3/8”-24 UNEF to 1/2”-20 UN Adaptadors (10) 3/8”-24 UNEF a
PAGE 12
Notes / Notas / Notes www.deltafaucet.