Instruction manual

5
A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should
be protected with a 20 Amp time lag fuse. Before connecting the machine to the power line, make sure the electric
current is of the same characteristics as indicated on the machine. All line connections should make good contact.
Running on low voltage will damage the machine.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.
POWER CONNECTIONS
MOTOR SPECIFICATIONS
The 50-762 and 50-763 are wired for 230 volts, 60 HZ alternating current.
THIS MACHINE MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRIC SHOCK.
FOREWORD
The Delta Industrial Models 50-762 and 50-763 are Dust Collectors that will connect to woodworking machines that
accept a 4" diameter hose. The units each come with four 6 mil plastic collection bags and two 1 micron cloth filter
bags. The 50-762 has a three phase 230V 3HP motor, while the 50-763 has a single phase 230V 3HP motor.
FUNCTIONAL DESCRIPTION
The 50-762 and 50-763 dust collectors do not come with power cords. They must be permanently connected to the
building’s electrical system and grounded according to the National Electrical Code. Since they must be permanently
connected to the building’s electrical system, extension cords cannot be used with three phase machines. For
instructions on how to wire three phase or single phase motors, check the section “SINGLE AND THREE PHASE
WIRING” in this manual.
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE
CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED
IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE
ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO
ILLUSTRATE TECHNIQUE ONLY.