Use and Care Manual
3
Combining wood and
metal dust can create an explosion or fire hazard. This
unit is intended to filter non-explosive atmospheres
only.
Explosions or fire can result. This air cleaner is
intended for use where only dry airborne dust is
present. Its use should be limited to non-explosive,
non-metallic atmospheres.
1.
A unit incorrectly assembled can cause
injury.
2.
Knowledge is
safety.
3.
4.
Do not use the power cord as a hanging device. A
damaged power cord can cause electrical shock or
electrocution.
5.
A falling unit can cause serious injury.
Always keep a minimum of 7 feet between the bottom
of the unit and the floor surface to allow for sufficient
head clearance. Use only a chain rated for a minimum
of 150 lb. working load to adequately hold the unit.
Use steel S-Hooks that are at least 1/4" in diameter to
suspend the unit from the ceiling. Lag-type bolts used
to suspend the unit from the ceiling must be threaded
at least 1-1/2" into supporting structural members.
6.
7.
Clogged intakes
or exhausts can cause an explosion and/or fire.
8.
Avoid all exposure to rotating parts to prevent
injury.
9.
Dust and other small debris will go directly
to the motor, causing over-heating and the potential for
fire and/or explosion.
10.
Exposed fan blades can
cause severe cuts. Make certain that the unit is
disconnected from the power source.
11. Clogged filters
can increase the potential for fire or explosion. Follow
all instructions for changing and cleaning filters.
12.
A damaged
power cord can cause shock or electrocution. Safely
store power cord on the unit to eliminate tripping
hazards.
13.
An accidental start-up can cause
serious injury.
•
Learn the unit’s application and limitations as well as the specific hazards peculiar to it.
•
Cluttered areas and benches invite accidents.
•
Don’t use this unit in damp or wet locations, or expose it to rain.
Keep work area well-lighted.
•
All children and visitors should be kept a safe distance from work area.
•
before servicing.
•
Before further use of the unit, properly repair or replace any part that is damaged.