Installation Guide

ManualsBrandsDelta ManualsBathroom Sink Faucets559HA-GPM-DST

7/26/18 Rev. C

Para instalación fácil de su llave Delta

usted necesitará:

•LEER TODAS las instrucciones completamente

antes de empezar.

•LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

•ToREAD ALL the instructions completely

before beginning.

•To READ ALL warnings, care, and

maintenance information.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Pour installer votre robinet Delta

facilement, vous devez:

•LIRE TOUTES les instructions avant de débuter;

•LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien;

SINGLE HANDLE HIGH ARC LAVATORY

CENTERSET FAUCETS

LLAVES DE AGUA – GRIFOS MONOMANDO

DE ARCO ALTO PARA LAVAMANOS

ROBINETS CENTERSET COL-DE-CYGNE

À UNE MANETTE POUR LAVABO

78222

www.deltafaucet.com

SILICONE

1/8"

Models/Modelos/Modèles

559HA-▲-DST

Series/Series/Seria

Trinsic

1/8"

1/8 po

SILICONE

▲Specify Finish

Especifíque el Acabado

Précisez le Fini

Summary of content (8 pages)

PAGE 1
SINGLE HANDLE HIGH ARC LAVATORY CENTERSET FAUCETS 78222 LLAVES DE AGUA – GRIFOS MONOMANDO DE ARCO ALTO PARA LAVAMANOS ROBINETS CENTERSET COL-DE-CYGNE À UNE MANETTE POUR LAVABO Models/Modelos/Modèles 559HA-▲-DST Series/Series/Seria Trinsic® HA ▲Specify Finish Especifíque el Acabado Précisez le Fini You may need/Usted puede necesitar/ Articles dont vous pouvez avoir besoin: For easy installation of your Delta faucet you will need: • To READ ALL the instructions completely before beginning.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.
PAGE 3
1 A. B. 4 2 3 1 5 B. Place metal bracket (3) over mounting stud (4) under sink. Secure with mounting nut / wrench (5). A. Slide single hole gasket (1) up over tubes and mounting stud. Position faucet (2) and gasket on sink. Option: If sink is uneven, use silicone under the gasket. A. Deslice el empaque de un orificio (1) sobre las tuberías y el perno de instalación. Coloque la llave de agua (2) y el empaque en el lavamanos.
PAGE 4
2 A. B. OR 2 1 O 2 3 OU 4 3 2 1 1 2 4 Water Line Connections A. Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (2) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (3) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 5
Incorrect Installation Instalación Incorrecta Installation Incorrecte Correct method Método Correcto Bonne méthode 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3. Insert tube into outlet fitting (4).
PAGE 6
3 4 1 2 1 1 3 2 2 2 1 3 1 2 3 3 3 Side View / Vista lateral / Vue latérale Place a bucket below the outlet fitting and move the valve handle (1) to the open mixed position.Then, while holding the outlet tube (2) with o-rings over the bucket, slowly open and close the supply stops (3). This will prevent debris from being lodged in the tube and aerator. 1 Connect outlet tube (1) to spout tube (2) with supplied clip (3). Pull on tube (1) to ensure it is firmly attached.
PAGE 7
5 2 1 2 3 4 5 Maintenance If faucet exhibits very low flow: A. Remove and clean aerator (1) with supplied wrench (2), or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (3). When reinstalling parts, make sure bonnet nut (4) is tightened securely with a wrench.* If faucet leaks from under handle: Remove handle and pull off trim cap (5). Using a wrench, ensure bonnet nut (4) is tight. If leak persists–SHUT OFF WATER SUPPLIES. Replace valve cartridge (3).
PAGE 8
Model / Modelo / Modèle 559HA-DST ▲Specify Finish Especifíque el Acabado Précisez le Fini RP71260 (1.5 GPM) RP71260-1.2 (1.2 GPM) Aerator, Gasket & Wrench Aireador, Empaque y Llave Aérateur, Joint et Clé RP73000 Valve Assembly Ensamble de la válvula Soupape RP47028 Gasket Empaque Joint RP7449 O-Ring Anillo “O” Joint Torique RP75405 Bonnet Nut Tuerca del Bonete Chapeaux Fileté RP73805 (1.