Exploded Parts

Page 3

205858 Rev. A

STEP 7b. CALIBRATION

After power is applied to the driver board, it generates 5 quick beeps 3 times which

prompts the installer to step away from the unit. During this process the water will

turn ON for approximately 10 seconds and proceed to shut off. An additional 5 beeps

once will then be heard indicating calibration is complete.

STEP 8. TEST FOR OPERATION

Test for operation. If OK, then close lid - Use caution not to damage wires or

components on electronic driver board. See Fig 6. Secure lid using screws.

If faucet leaks from spout outlet: SHUT OFF WATER SUPPLIES. Check proper

solenoid connection. Replace solenoid if problem persists. If faucet exhibits

very low flow: A) Remove and clean Spray Outlet or B) SHUT OFF WATER

SUPPLY. Clean or replace Screen Assembly (2). If unit does not work

properly, see Trouble Shooting Guide on page 5.

INSTALLATION AND SET UP INSTRUCTIONS

Installation should be in accordance with local plumbing and electrical codes.

FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION.

Fig. 5

NOTE: Always make

sure driver board is in

place before inserting

the battery pack. Use

caution not to pinch

wires or damage

components on the

electronic driver board.

Fig. 6

STEP 9. BASIC OPERATION AFTER CALIBRATION

Proximity™ sensing technology works by creating an electrical field around

a conductor (the spout) and monitoring the change in capacitance that

the conductor undergoes. The change in capacitance (the ability to store

an electrical charge) is brought on by a 2nd conductor (a human body)

entering the Proximity™ field. As the human hand enters and leaves the

vicinity of the electrical field around the spout, the solenoid is opened and

closed accordingly. It is critical in the installation process that all electrical

and mechanical connections be as tight and rigid as possible, ensuring a

smooth signal is carried from the driver board to the spout, and back again.

After calibration, test the function of the product by

placing your hands within close proximity of the

spout (ensuring hands are moving as if washing

hands). The solenoid will stay open while hands

are moving, then close once hands are removed

from the sensing zone.