Specification Sheet

Electronic Faucets
Hardwire - 4" Lavatory - CAST one-piece body with
H2Optics® (Product supplied with a Converter to
convert 24VAC to 6 VDC)
Model No: 591T0238TR
SPECIFICATION:
Hardwire - 4" Lavatory - CAST one-piece body with H2Optics® (Product
supplied with a Converter to convert 24VAC to 6 VDC)
Spout#: 2 - 4" (102mm) Cast Lavatory Spout
Outlet#: 3 - Vandal Resistant 1.5 gpm (5.7L/min) Flow Control Aerator
Supplied as trim parts only – requires separate order of ELAVT0008ARI
rough-in to have complete product
COMPLIES WITH:
CSA certified.
Complies to ASME A112.18.1/CSA B125.1
Indicates compliance to ICC/ANSI A117.1
Patented
Verified compliant with 0.25% weighted average Pb content regulations
NOTE 1: For optimum performance of this product, we recommend a
system pressure between 20 and 80 PSI static. This product will operate up
to a maximum of 125 PSI static per ANSI and CSA requirements. However,
we do not recommend pressures above 80 PSI. Thermal expansion or
leaking pressure reducing valves may require use of expansion tanks or
relief valves to ensure your system never exceeds its maximum intended
pressure setting.
NOTE 2: Designed for routine 171°F (77°C) disinfection cycles up to 30
minutes.
NOTE 3: Control Box #8 is not recommended for high temperature
disinfection cycles as the thermostatic mixing valve limits the higher
temperature flow output
Outlet options 2, 3 and 6 are EPA WaterSense listed
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
Hands free (touchless) operation.
Water flows when sensor is activated.
Water flow stops upon de-activiation of sensor.
Adjustable auto shut-off feature. Factory set to 45 seconds. Will reset once
obstruction is removed.
Adjustable sensing distance 76 to 381mm (3" to 15") factory set to 229mm
(9") (± 3.0")
Low battery audible beep (for battery models only) will activate after faucet
shuts off when approximately 1500 cycles remain.
Metering mode with selectable flow times of 7 seconds to 4 minutes, factory
set off.
Periodic Rinse feature, time adjustable in 6 hour increments up to 2 days.
Selectable rinsing lengths from 10 to 180 seconds. Factory set off.
OPERATION:
NOTES:
Verified to <0.25% Pb average wetted surface regulations
CA/VT Compliance:
This COMPLETE SERIES is ONLY available as CA/VT Compliant product
as of April 15, 2013.
The Product Numbers have NOT changed.
Control Box(8TR) -NOTES:
Requires Rough-in Product Number ELAVT0008ARI to be ordered
separately - seeELAVT0008ARI
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced January 17, 2017.
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - (317) 848-1812
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - (905) 712-3030

Summary of content (2 pages)