Installation Sheet

ManualsBrandsDelta ManualsCommercial ProductsDelta Commercial 0.35 GPM Centerset Battery Operated Electronic Bathroom Faucet with Solenoid Control Valve

Page 1

209125 Rev. A

591T__ 2 __ __

Write purchase model number here for future reference

PLEASE LEAVE this M&I Sheet with the owner, maintenance plumber, etc. as

items relating to ongoing maintenance suggestions and procedures are included.

NOTE: Control Box #0 and #1 are designed for routine

171°F (77°C) disinfection cycles up to 30 minutes.

Control Box #8 is not recommended for high temperature

disinfection cycles as the thermostatic mixing valve limits

the higher temperature flow output.

NOTE: For optimum performance of this product, we

recommend a system pressure between 20 and 80 PSI

static. This product will operate up to a maximum of 125

PSI static per ANSI and CSA requirements. However,

we do not recommend pressure above 80 PSI. Thermal

expansion or leaking pressure reducing valves may

require use of expansion tanks or relief valves to ensure

your system never exceeds its maximum intended

pressure setting.

060638A

Vandal Resistant Laminar Outlet

with Antimicrobial by Agion

1.5 GPM (5.7 L/min)

060640A

Vandal Resistant Flow Control

Aerator and Wrench

1.5 GPM (5.7 L/min)

061203A

Vandal Resistant Laminar

Outlet with Wrench

0.5 GPM (1.9 L/min)

061176A

Vandal Resistant Laminar

Outlet with Wrench

1.0 GPM (3.8 L/min)

061104A

Vandal Resistant Flow Control

Non-Aerating Spray Outlet

with Wrench

0.35 USGPM (1.3 L/min)

RP31704 - Optional

Vandal Resistant Spray

Outlet with Wrench

0.5 GPM (1.9 L/min)

060566A - Optional

Vandal Resistant Spray

Outlet with Wrench

1.0 GPM (3.8 L/min)

RP6001

Nut & Washer

060765A

Wrench

063211A

Spout Assembly

Fig. 1

RP30523

Braided Hose

063131A

3/8” x 3/8” Compression

Connector, Nut and Ferrule

063127A

Solenoid Valve

with 3/8”

Compression

Connectors

OPTION LIST

TRANSFORMERS

060704A

Transformer 110 to 24 VAC 20VA

up to 5 Electronic Valves

060771A

Transformer 110 to 24 VAC 40VA

up to 10 Electronic Valves

060772A

Transformer 110 to 24 VAC 100VA

up to 25 Electronic Valves

209125 209125 209125 209125 209125

061031A

Deck Gasket (3/pkg)

Note: See page 3 for

parts breakdown on

recessed mount boxes.

www.specselect.com

060683A

24 VAC/6.4 VDC

Converter

061256A

36” Cable Extension

Accessories

060681A

Battery Holder

063128A

Battery Box Assembly less driver

board and battery holder

063131A

3/8” Comp Connect Nut

and Ferrile

060909A

Screen Assembly

060908A

Solenoid Holder

063127A

Solenoid Valve with 3/8”

Compression Connectors

061252A

Dual Driver Board

Masco H

Optics

& Proximity

060906A

Surface

Mount Housing

060905A

Cover Gasket

Summary of content (8 pages)

PAGE 1
591T__ 2 __ __ 061176A Vandal Resistant Laminar Outlet with Wrench 1.0 GPM (3.8 L/min) 209125 RP31704 - Optional Vandal Resistant Spray Outlet with Wrench 0.5 GPM (1.9 L/min) 209125 060566A - Optional Vandal Resistant Spray Outlet with Wrench 1.0 GPM (3.8 L/min) 060765A Wrench 061031A Deck Gasket (3/pkg) RP6001 Nut & Washer OPTION LIST Accessories 209125 RP30523 Braided Hose 060683A 24 VAC/6.
PAGE 2
Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION AND SET UP INSTRUCTIONS FOR SURFACE MOUNT HOUSING: CONTROL BOX #0 STEP 1. FAUCET INSTALLATION Fig. 2 13" (331 mm) Max. Connect 20” braided hose to spout inlet. Clean deck/sink surface where faucet will be mounted. Mount faucet to sink using nut(s) and washer(s) provided (Fig. 1).
PAGE 3
Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 STEP 1. ROUGH IN Note: Wires connecting between box(es) and from transformer must be protected from abrasion, and being pulled at connections. They also may have to be fished through at a later stage of construction.
PAGE 4
INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 STEP 3. CONNECT WATER SUPPLY Fig. 8 Install sink and connect drainage to rough in. See applicable Fig. 6 or Fig. 7. Please note that the connection and fittings are supplied by the installer to connect 1/2” nominal sweat at the box outlet and 3/8” compression at the spout. Connect water supply through to spout. Assure supply lines are completely flushed and free of debris. Sensor STEP 4.
PAGE 5
INSTALLATION AND SET UP INSTRUCTIONS FOR RECESS MOUNT HOUSING: CONTROL BOXES #1 & 8 STEP 7. TEST FOR OPERATION Operation Illustration Minimum Recommended Distance 9” (229mm) Test for operation. If unit does not work properly, see Troubleshooting Guide on page 7. STEP 8. MAKING ADJUSTMENTS Sensing Zone 9” (228mm) default If adjustments are required. Note factory defaults for program shown in Quick Reference Chart.
PAGE 6
Function Function Setting To adjust settings, press and hold MODE (yellow pushbutton on left hand side) until the Function symbol appears. Once in Adjustment Mode, keep pressing MODE until desired Function is reached (see Quick Reference Table). To change Function Setting, press and release TOGGLE (white pushbutton on right hand side) until desired Function Setting is reached (see Quick Reference Table). Note: Will leave Adjustment Mode after 5 seconds.
PAGE 7
CARE INSTRUCTIONS This Delta Commercial faucet is designed and engineered in accordance with the highest quality and performance standards. With proper care, it will give years of trouble free service. Care should be given to the cleaning of this product. Although the chrome finish is extremely durable, it can be DAMAGED by ACIDIC CLEANERS (i.e. cleaners designed specifically for vitreous china lavatories and water closets), HARSH ABRASIVES or POLISH.
PAGE 8
Delta Commercial Faucet Limited Warranty All parts of the Delta® HDF® and TECK® faucets are warranted to the original consumer purchaser to be free from defects in material, finish and workmanship for a period of five (5) years unless otherwise specifically stated in the catalogue and price book. This warranty is made to the original consumer purchaser and shall be effective from date of purchase as shown on purchaser’s receipt.