Installation Sheet

ManualsBrandsDelta ManualsCommercial ProductsDelta Commercial 0.35 GPM Centerset Battery Operated Electronic Bathroom Faucet - Less Rough-In Valve

Page 3

STEP 8. TEST FOR OPERATION

Test for operation. If OK, then close lid - Use caution not to damage wires or

components on electronic driver board. Route wires through notches/

openings in the box. See Fig 6. Secure lid using screws.

If faucet leaks from spout outlet:

SHUT OFF WATER SUPPLIES. Check proper solenoid connection. Replace

solenoid if problem persists.

If faucet exhibits very low flow:

A) Remove and clean Aerator, or

B) SHUT OFF WATER SUPPLY. Clean or replace Screen Assembly (1).

If unit does not work properly, see Trouble Shooting Guide on pages 16 & 17.

Installation should be in accordance with local plumbing and electrical codes.

FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION.

STEP 9. BASIC OPERATION AFTER CALIBRATION

Proximity

sensing technology works by creating an electrical field around a

conductor (the spout) and monitoring the change in capacitance that the conductor

undergoes. The change in capacitance (the ability to store an electrical charge) is

brought on by a 2nd conductor (a human body) entering the Proximity

field. As the

human hand enters and leaves the vicinity of the electrical field around the spout, the

solenoid is opened and closed accordingly. It is critical in the installation process that all electrical and mechanical connections be as tight and

rigid as possible, ensuring a smooth signal is carried from the driver board to the spout, and back again.

www.specselect.com

209493 Rev. A

Fig. 6

NOTE: Always make

sure driver board is in

place before inserting

the battery pack. Use

caution not to pinch

wires or damage

components on the

electronic driver board.

Trap jacket

of cable in

hole for strain

relief.

DO NOT

INSTALL

9V BATTERY

591TPxxx0 Battery Operated Surface Mount Box #0

INSTALLATION AND SET UP INSTRUCTIONS

After calibration, test the function of the product by placing your

hands within close proximity of the spout (ensuring hands are

moving as if washing hands). The solenoid will stay open

while hands are moving, then close once hands are removed

from the sensing zone.