Specification

Delta reserves the right (1) to make changes in specifications and materials, and (2) to change or discontinue models, both without notice or obligation.
Dimensions are for reference only. See current full-line price book or www.specselect.com for finish options and product availability.
Note: Measurements may vary ± 6mm (0.25")
Electronic Proximity
®
Sensing
Technology Lavatory Faucets
DSP–600T Rev. J Page 4.C.21
Batteries included on all battery models. Flow Rates are at 60 PSI.
Refer to www.specselect.com for individual models. Note: Use this page as a product submittal sheet.
SPECIFICATION: (example)
• Deck mount electronic lavatory faucet
• Cast chrome plated brass spout
• Proximity
®
Sensing Technology
• Hardwire units supplied with 24 VAC to 6 VDC
converter (Transformer required). (Specify separately)
• Battery units supplied with 4 ‘C’ cell batteries
• Surface mount control box
• Mixing valve required (Order separately)
1.5 GPM (5.7 L/min) Laminar Outlet
❏
600T040 Hardwire
❏ 601T040 Battery Operated
0.5 GPM (1.9 L/min) Laminar Outlet
❏ 600T050 Hardwire
❏ 601T050 Battery Operated
0.35 GPM (1.32 L/min)
Non-Aerating Spray Outlet
❏ 600T090 Hardwire
❏ 601T090 Battery Operated
OPERATION:
• Hands free (touchless) operation.
• No visible sensor, the spout is the sensor.
• Water flows when sensing is activated.
• Water flow stops upon de-activation of sensing.
• Adjustable sensing distance factory set to 76 mm (3").
• Low battery audible beep (for battery models only)
will activate after faucet shuts off when approximately
1500 cycles remain.
• Adjustable auto shut off feature. Factory set to 45 seconds.
• Metering mode with selectable flow times of 7 seconds
to 4 minutes, factory set off.
• Periodic Rinse feature, time adjustable in 6 hour
increments up to 2 days. Selectable rinsing lengths
from 10 to 180 seconds. Factory set off.
NOTE 1: For optimum performance of this product,we recommend a
system pressure between 20 and 80 PSI static. This product will
operate up to a maximum of 125 PSI static per ANSI and CSA
requirements. However, we do not recommend pressures above
80 PSI. Thermal expansion or leaking pressure reducing valves may
require use of expansion tanks or relief valves to ensure your
system never exceeds its maximum intended pressure setting.
NOTE 2: Designed for routine 180°F (82°C) disinfection cycles up to
10 minutes.
NOTE 3: Hardwire Proximity models not for use on enamel covered
metal sinks.
2.5
2
1.5
1
.5
00
0
1
2
3
4
5
6
7
8
9
10 20 30 40 50 60 70 80
Line Pressure (psig)
FLOW
(L/min.)
FLOW
(GPM)
6_ _ T040
6_ _ T050
6_ _ T090
FLOW RATE vs PRESSURE
Outlet Flow Rates
SIDE VIEW
FRONT VIEW
ELECTRONIC DECK MOUNT LAVATORY FAUCET
VANDAL PROOF SURFACE MOUNT HOUSING
Approvals:
• CSA certified
• Complies to ASME A112.18.1/CSA B125.1
•
Indicates compliance to
ICC/ANSI A117.1
•
1.5 GPM (5.7 L/min) outlet option is
EPA WaterSense listed
Verified compliant with 0.25% weighted average Pb
content regulations
( Contact Delta Representative for
State and/or Local Approvals.)
Patented
®
Sensing Wire
711 mm (28")
32 mm (1.25")
Dia. Hole Required
To Control Box
3/8"
Compression
38mm
(1.5")
Max Deck
Thickness
46 mm
(1.8")
113 mm
(4.44")
96.5 mm
(3.8")
124 mm
(4.9")
50 mm
(2.0")
152 mm
(6.0")
63.5 mm
(2.5")
266.7 mm
(10.5")
062021A 102 mm (4.0") COVERPLATE
Reduces Max. Deck Thickness to 28 mm (1 1/8")
061119A 204 mm (8.0") COVERPLATE
Reduces Max. Deck Thickness to 28 mm (1 1/8")
Brilliance
®
Stainless Finish
❏ Add suffix ”-SS” to
Product Number. Available
on single hole models and
062021A only.
Available Option for
Field Conversion
❏ 060651A
3 Position Switch
See DSP-ELACC for
detailed specification.
3/8"
Compression
Connection
Outlet
Inlet 3/8" NPT or
3/8" Compression
Adaptor (Supplied)
36 mm
(1.43")
1/8" Allen Screw
Recommended
381 mm
(15" max.) to
top of counter
146 mm
(5.73")
89 mm
(3.5")
MAX.
101 mm
(3.96")
139 mm
(5.47")
Battery
Pack
Battery Operated – Box shown.
Hardwire Version comes complete with Watertight
Connector and Hardwire Converter 24VAC to 6VDC.
Hardwire with Battery Backup
❏ Add suffix ”-BB” to Product Number.
Available on Hardwire models only.
See DSP-BB for detailed specification.
DSP–600T Rev. J