Specification Sheet

Electronic Faucets
Hardwire - Single Hole Deck Mount Gooseneck
Faucet
Model No: 620TP3310
SPECIFICATION:
•
Supplied as complete product
•
Proximity® Sensing Technology
•
Chrome plated gooseneck spout
•
Battery (4 ‘C’ cell) or Hardwire (24 VAC) deckmount electronic handwash
system
•
Adjustable sensing range and timeout
•
Forged brass solenoid valve
•
Surface mount housing
•
Mixing valve required (order separately)
•
Serviceable filter screen upstream of the valve
•
Hardwire - Single Hole Deck Mount Gooseneck Faucet
•
Chrome Finish
•
Spout#: 3 - Single Hole Deck Mount Gooseneck Spout
•
Outlet#: 1 - Vandal Resistant 2.2 gpm (8.3 L/min.) Laminar Outlet
•
Solenoid and Controller in Surface Mount Housing- REQUIRED SINGLE
TEMPERED WATER SUPPLY
COMPLIES WITH:
•
CSA certified
•
Complies to ASME A112.18.1/CSA B125.1
•
Indicates compliance to ICC/ANSI A117.1
•
Patented
•
Outlet options 2 and 6 are EPA WaterSense listed
•
Verified compliant with 0.25% weighted average Pb content regulations
•
NOTE 1: For optimum performance of this product, we recommend a
system pressure between 20 and 80 PSI static. This product will operate up
to a maximum of 125 PSI static per ANSI and CSA requirements. However,
we do not recommend pressures above 80 PSI.Thermal expansion or
leaking pressure reducing valves may require use of expansion tanks or
relief valves to ensure your system never exceeds its maximum intended
pressure setting.
•
NOTE 2: Designed for routine 180°F (82°C) disinfection cycles up to 10
minutes.
•
NOTE 3: Use 3-conductor 18AWG wire between transformer and hardwire
converter/driver board earth ground.
•
NOTE 4: Use Delta Commercial approved transformers and mount the
transformer a minimum of 6 inches away from the Delta driver board
enclosure.
•
NOTE 5: Refer to Proximity Application Notes for installation best practices,
proper grounding and wiring diagrams on www.specselect.com.
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
Hands free (touchless) operation.
•
No visible sensor, the spout is the sensor.
•
Water flows when sensing is activated.
•
Water flow stops upon de-activiation of sensing.
•
Adjustable sensing distance factory set to
•
76 mm (3").
•
Low battery audible beep (for battery models only) will activate after faucet
shuts off when
•
approximately 1500 cycles remain.
•
Adjustable auto shut off feature. Factory set to 45 seconds.
•
Metering mode with selectable flow times of 7 seconds to 4 minutes, factory
set off.
•
Periodic Rinse feature, time adjustable in 6 hour increments up to 2 days.
Selectable rinsing lengths from 10 to 180 seconds. Factory set off.
OPERATION:
NOTES:
Control Box(0) - Supplied as COMPLETE PRODUCT ONLY
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced January 23, 2017.
- 1.0.25277
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]