Operating Guide

ManualsBrandsDelta ManualsBathTesla Single Hole Single-Handle Touch2O Technology Vessel Bathroom Faucet in Polished Nickel

TOUCH

TECHNOLOGY LAVATORY FAUCETS

LLAVES DE LAVAMANOS DE TECNOLOGÍA TOUCH

ROBINETS DE LAVABO AVEC TECHNOLOGIE TOUCH

Model/Modelo/Modèle

COMPEL

, LAHARA

, DRYDEN™,

ADDISON™, TESLA

& TALBOTT™

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

04/25/2019 Rev. F

You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:

Read all instructions prior to installation.

Lea todas las instrucciones antes de hacer la instalación.

Veuillez lire toutes les instructions avant l’installation.

93546

To access additonal technical documents & product info, visit www.deltafaucet.com/p/Your-Model-Number-Here

(example: www.deltafaucet.com/p/9159T-DST)

Para acceder a documentos técnicos adicionales e información sobre el producto, visítenos en www.deltafaucet.

com/p/Your-Model-Number-Here (ejemplo: www.deltafaucet.com/p/9159T-DST)

Pour avoir accès à des documents techniques supplémentaires et à de l’information sur le produit, visitez www.delta-

faucet.com/p/Votre-numéro-de-modèle-ci (exemple : www.deltafaucet.com/p/9159T-DST)

www.deltafaucet.com

1-800-345-DELTA (3358)

customerservice@deltafaucet.com

3/32"

538T-DST

15938T-DST

551T-DST

751T-DST

592T-DST

552TLF

752TLF

561T-DST

761T-DST

574T-DST

774T-DST

15960T-SS-DST

Summary of content (12 pages)

PAGE 1
93546 TOUCH2O® TECHNOLOGY LAVATORY FAUCETS LLAVES DE LAVAMANOS DE TECNOLOGÍA TOUCH2O® ROBINETS DE LAVABO AVEC TECHNOLOGIE TOUCH2O® Model/Modelo/Modèle COMPEL®, LAHARA®, DRYDEN™, ADDISON™, TESLA® & TALBOTT™ Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish. All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.
PAGE 3
2 1 1 Arriba Top Dessus 2 2 2 3 OPTIONAL ESCUTCHEON INSTALLATION INSTALACIÓN DE LA CHAPA OPCIONAL INSTALLATION AVEC LA PLAQUE DE FINITION FACULTATIVE 2 1 2 1 2 1 3 Install the included check valves on both hot and cold water supplies. Finger tighten. Tighten two additional turns with wrench. Loop the supply lines, if possible, to avoid having to cut them. Finger tighten both hot & cold sides. Tighten two additional turns with wrench.
PAGE 4
5 1 2 1 2 2 1 Place bucket under faucet outlet tube. Slowly open water supply stop to flush line. This will prevent debris from being lodged in the faucet. Close water supply and remove bucket. Coloque un balde o cubo debajo del tubo de salida de la llave de agua/grifo. Lentamente abra el control del límite del suministro de agua para descargar la línea. Esto evitará que los residuos se atasquen en la llave de agua/grifo. Fermez le robinet d’alimentation et enlevez le seau.
PAGE 5
8 9 1 1 2 Wire must extend away from solenoid. Asegúrese que el alambre se extiende alejado del solenoide. Prenez soin de placer les fils à l’écart de l’électrovanne. 10 “AA” Batteries (Last up to 2 years) Pilas “AA” (Duran hasta 2 años) Piles « AA » (Durée utile de 2 ans) 1 2 “C” Batteries (Last up to 5 years) Pilas “C” (Duran hasta 5 años) Piles « C » (durée utile de 5 ans) Important: Place batteries in holder, secure cap as shown. For proper functionality DO NOT tie, twist or bunch the wires.
PAGE 6
11 12 A. B. 1 C. 2 3 2 3 2 1 1 Proper Placement Meilleure solution Bonne position Lay on cabinet floor. Remove stopper (1) and flange (2). Screw nut (1) all the way down. Push washer (2) and gasket (3) down. Remove tailpiece (1) from body (2), add plumber tape (3), replace tailpiece. Colóquelo en el piso del gabinete como. Quite el tapón (1) y el reborde (2). Atornille la tuerca (1) completamente hasta abajo. Empuje la arandela/roldana (2) y el empaque (3) hacia abajo.
PAGE 7
14 15 FOR MANUAL BYPASS PARA (BYPASS) PASO MANUAL POUR UTILISER LE ROBINET MANUELLEMENT B. A. 2 1 C. 1 D. 4 3 Shut off hot and cold water supplies. Move faucet handle to the off position. Disconnect wires and remove clips (1) from solenoid (2). Using one of the clips (1), attach hose (3) directly to the outlet (4). Pull down moderately to ensure connection has been made. Check all connections at arrows for leaks. Re-tighten if necessary. IMPORTANT: Do NOT overtighten.
PAGE 8
538T-DST, 15938T-DST & 15960T-DST 551T-DST & 751T-DST 592T-DST 561T-DST & 761T-DST 552TLF & 752TLF 574T-DST & 774T-DST 8 9 5 5 5 5 10 4 4 4 3 11 4 4 3 7 3 3 1/16" 1/16 po 3 12 1 1 1 6 2 1 2 2 13 Flow Restrictor Inside Restrictor de flujo interior Limiteur de débit à l’intérieur 2 Maintenance If faucet exhibits very low flow: A. Remove aerator (1) with supplied wrench (2) and clean MODELS 561T-DST & 761T-DST Refer to step 4 of installation to flush debris at the outlet.
PAGE 9
LED Guide Quick Tips for your Delta® Touch2O® Technology Bathroom Faucet. If LED (2) is: Solid Blue - Solenoid valve is open, water temperature is less than 80°F (27°C). 1. Operation is simple! Place your hands within 4” of the faucet and it will turn on and stay on until you remove them. 2. By tapping the faucet, it will run for up to 2 minutes or until you tap it off. 3. Use the handle to control temperature and volume for both manual and electronic operation. 4.
PAGE 10
For Models 538T, 551T and 751T ONLY. Para los modelos 538T, 551T y 751T SOLAMENTE. Pour les modèles 538T, 551T et 751T SEULEMENT. WARNING Scald possible. May result in personal injury. Adjust handle limit clockwise per these instructions. ADVERTENCIA Posible escaldadura. Puede resultar en lesiones personales. Ajuste el límite de la manija hacia la derecha, de acuerdo a estas instrucciones. MISE EN GARDE Possibilité d’ébouillantage et de blessures.
PAGE 11
CUSTOM FIT CONNECTIONS / CONEXIONES ESPECIALES / SPÉCIAUX TUYAUTERIE BRANCHEMENT Installer accepts the responsibility to cut supply tubing in a way that allows a leak-free joint to be created. Brizo is not responsible for tubing that is cut too short or cut in a way that will not allow for a leak-free joint. Must use RP50952 sleeves supplied with model and nuts included on supply lines. Tube cut must be straight. See plastic sleeve installation found in RP50952 and included below for more information.
PAGE 12
Solenoid Troubleshooting Note: Normal operation of the faucet will turn off water flow if faucet is not touched for 4 minutes. 1. If your spout indicates three red flashes, replace the batteries. If the spout still indicates three red flashes, please replace the solenoid assembly**. (see manual bypass option below*) 2. If neither water or light indication are working properly, a. Check that all six batteries or inserted in the proper orientation. b. Replace your batteries c.