Owners Manual

ManualsBrandsDelta ManualsBathroom FaucetsDelta Dorval 1.2 GPM Single Hole Bathroom Faucet - Limited Lifetime Warranty

12/10/2018 Rev. A

Models/Modelos/Modèles

856-DST & 857-DST

Series/Series/Seria

DORVAL

™

Read all instructions prior to installation.

Lea todas las instrucciones antes de

hacer la instalación.

Veuillez lire toutes les instructions avant

l’installation.

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

MONOBLOCK BATHROOM FAUCETS

GRIFOS/LLAVES DE AGUA PARA BAÑOS

MONOBLOCK

ROBINET MONOBLOC POUR SALLE DE

BAIN

102333

www.deltafaucet.com

1-800-345-DELTA (3358)

customerservice@deltafaucet.com

To access additonal technical documents & product info, visit www.deltafaucet.com/p/Your-Model-Number-Here

(example: www.deltafaucet.com/p/9159T-DST)

Para acceder a documentos técnicos adicionales e información sobre el producto, visítenos en www.deltafaucet.com/p/Your-

Model-Number-Here (ejemplo: www.deltafaucet.com/p/9159T-DST)

Pour avoir accès à des documents techniques supplémentaires et à de l’information sur le produit, visitez www.deltafaucet.

com/p/Votre-numéro-de-modèle-ci (exemple : www.deltafaucet.com/p/9159T-DST)

Summary of content (6 pages)

PAGE 1
MONOBLOCK BATHROOM FAUCETS 102333 GRIFOS/LLAVES DE AGUA PARA BAÑOS MONOBLOCK ROBINET MONOBLOC POUR SALLE DE BAIN Models/Modelos/Modèles 856-DST & 857-DST Series/Series/Seria DORVAL™ Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. You may need/Usted puede necesitar/ Articles dont vous pouvez avoir besoin: Read all instructions prior to installation. Lea todas las instrucciones antes de hacer la instalación.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish. All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.
PAGE 3
1 A. 2 2 1 2 1 B. 2 1 4 2 1 OVERTIGHTEN APRIETES DEMASIADO TROP SERRER 3 2 SEALANT SELLADORES PRODUITS D’ÉTANCHÉITÉ 1 5 For single hole mount: A. Slide single hole gasket (1) up over tubes and mounting stud. Position faucet (2) and gasket on sink. Option: If sink is uneven, use silicone under the gasket. Ensure fittings are free of debris. Secure nut to supply valve and hand tighten, then one additional turn with wrench.
PAGE 4
CUSTOM FIT CONNECTIONS / CONEXIONES ESPECIALES / SPÉCIAUX TUYAUTERIE BRANCHEMENT Installer accepts the responsibility to cut supply tubing in a way that allows a leak-free joint to be created. Brizo is not responsible for tubing that is cut too short or cut in a way that will not allow for a leak-free joint. Must use RP50952 sleeves supplied with model and nuts included on supply lines. Tube cut must be straight. See plastic sleeve installation found in RP50952 and included below for more information.
PAGE 5
A. B. E. D. C. 1 SIL NE I CO 3 1 2 3 2 3 2 1 1 1 F. G. 4 2 2 H. 5 4 3 2 1 5 1 2 3 2 1 Step 3b Metal Pop-Up A. Remove stopper (1) and flange (2). B. Screw nut (1) all the way down. Push washer (2) and gasket (3) down. C. Remove tailpiece (1) from body (2), add plumber tape (3), replace tailpiece. Step 3c D. Apply silicone to underside of flange (1). Insert body (2) into sink. Screw flange (1) into body (2). Pull 3a assembly (2) E. Pivot (1) must face faucet.
PAGE 6
4 4 3 5 1 6 2 Maintenance If faucet exhibits very low flow: A. Remove and clean aerator (5), or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (4). When reinstalling parts, make sure bonnet nut (3) is tightened securely with a wrench. If faucet leaks from under handle: Remove handle finial (1), screw, handle (2) and bonnet nut (3). When reinstalling parts, ensure bonnet nut (3) is tight. If leak persists–SHUT OFF WATER SUPPLIES. Replace valve cartridge (4).