Specification Sheet

Electronic Showers
Hardwire Operated (860T1) - Push button electronic
shower system
Model No: 860T178
SPECIFICATION:
•
Push button electronic shower system
•
Hardwire – 24 VAC to 6 VDC or Battery – 4 “AA” 6 VDC
•
Stainless steel cover with S/S vandal resistant mounting screws
•
Metal mounting box
•
Field adjustable shower time
•
Slow closing solenoid valve
•
Integral stop
•
Tempered water supplied to solenoid valve (except control box options No.
3 and 6)
•
Hardwire Operated (860T1) - Push button electronic shower system
•
#7 30° Vandal Resistant, Forged Wallmount 1.36 gpm (5.15 L/min) @ 45
PSI (310 kPa) 1.5 gpm (5.7 L/max) @ 80 PSI (552 kPa)
•
Note: # 7 Showerhead supplied with 1/2" sweat outlet # 0, 3, 5 showerhead
supplied with 3/8 M.I.P. outlet shown
•
Tempered water supplied to solenoid valve
•
Models supplied without a showerhead must be used with showerheads
rated at 1.29 L/min @ 310 kPa (0.34 gpm @ 45 psi) or higher.
COMPLIES WITH:
•
ASME A112.18.1 / CSA B125.1
•
Indicates compliance to ICC/ANSI A117.1
•
Control/Sensor Box Option 7, Pressure Balancing Valve, complies with
ASSE 1016
•
Control/Sensor Box Option 8, Thermostatic Mixing Valve, CSA certified to
ASSE 1069, 1070 and CSA B.125.3
•
Handshower back flow protection provided by two integral certified check
valves in series, which operate independently, ASME A112.18.3
•
Patented
•
NOTE FOR SHOWERS #6 AND #7: Not for use as an anti-ligature device.
•
Control / Sensor Box Option 8, Thermostatic Mixing Valve, CSA certified
and meets ASSE 1069, 1070.
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
Shower flows when push button is activated.
•
Adjustable maximum continuous run time
•
10 minutes.
•
Factory set to 3 minutes.
OPERATION:
NOTES:
Supplied as COMPLETE PRODUCT ONLY
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced February 13, 2017.
- 1.0.15265
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]