Specification Sheet

Metering Faucets
3 Hole 4" single push button metering faucet w/ brass
cover plate-0.5 gpm Vandal resistant outlet
Model No: 86T0104
SPECIFICATION:
•
Single push button non-mixing metering faucet
•
With cast brass cover plate
•
3 hole 4" centers(faucet does not lock to coverplate)
•
Vandal resistant push button
•
4.25" long rigid spout
•
Vandal resistant 0.5GPM (1.9L/min) flow control non-aerating spray outlet
•
Polished chrome plate finish
•
Slow close cartridge
COMPLIES WITH:
•
CSA certified.
•
Complies to ASME Standard A112.18.1/CSA B125.1.
•
Verified compliant with 0.25% weighted average Pb content regulations
•
Verified compliant with 0.25% weighted average Pb content regulations
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
Not Available
OPERATION:
NOTES:
Verified compliant with 0.25% weighted average Pb content regulations
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area. This spec was produced March 21, 2014.
- 1.0.21133
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]